Question about 1997 Mitsubishi Diamante

1 Answer

When I turn off my 97 Diamante after its been running for a few hours, i am not able to turn it back on for at least an hour to a couple of hours.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 70 Answers

Start cell or battery connection

Posted on Mar 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to program ECU for diamante 2003


If you dont know anything about the ECU.... I would take it to the dealer.... I had the same problem....ECU had to be replaced....they know what they're doing. I was out of there in a couple hours.

Sep 06, 2014 | Cars & Trucks

1 Answer

My 97 bonneville studders and stops running when engine gets hot 190-200 degrees


Hello. It seems either your water temperature sender is malfunctioning or your ignition module is overheating.

Apr 01, 2014 | 1997 Pontiac Bonneville

1 Answer

Land cruiser engine light


It is possible that would be the fault. The cpu runs from the alternator and unless it is charging the battery the intermittent contact would cause the cpu to turn on and off. Run fault codes to be sure.

Apr 23, 2013 | Cars & Trucks

1 Answer

I have a 97 jeep grand Cherokee, when it has sat for over an hour it takes 8-10 seconds of the starter running before it starts. If turned off after running, and started within a few minutes no problem,...


Fuel pump. The valve in the pump that stops the fuel from draining back into the tank is not working so you crank and crank until the fuel gets up front. Turn the key on but not to start for 5 seconds then off do it five times and then try to start it should start right up

Nov 27, 2011 | 1997 Jeep Grand Cherokee

1 Answer

I drove my 97 blazer yesterday and ran the a/c. It did not run cold but was cool. After getting back from my 4 hour drive, I went home and let it sit for a couple hours. When I went back out to start...


Probably the compressor causing the belt to squeak. Try spraying just a squirt of wd40 on the drive side of the belt. It the noise goes away, its the belt. If not, its the compressor drive.

Apr 30, 2011 | Chevrolet Blazer Cars & Trucks

1 Answer

I have 97 camaro it starts and drive fine but when i shut it off it wont start back up until it sits for a few hours?


We had a problem like this in our 97 Camaro with the V6. It would run fine until my wife went somewhere with it, parked it and then wouldn't restart. When it would sit for about an hour then it would start again. It turned out to be the crank position sensor, when the electronic part of it got hot enough it couldn't sense correctly and tell the computer how to time the spark. All it would do is crank without firing. So once we had that sensor replaced it ran good again. Good luck I hope this helps! I'm on to the next problem it's having, an occasional battery drain and a radio and electric windows that die when they want to and come back later. BuzzieTN

Sep 16, 2010 | 1997 Chevrolet Camaro

1 Answer

97 Lasabre- once it has been running, it want


What about the fuel pump relay. I had a car that would stall and would take 5 minutes to restart and it wound up being the fuel pump relay.

Jul 02, 2010 | Cars & Trucks

1 Answer

My car runs fine when Im driving it but when i turn it off the battery goes dead within a couple hours. what could be causing that


Ck the charging rate at the battery posts. Should be between 13.6 to 14.2 v. If higher than 14.2, it is not charging. If lower than23.6v it is over charging. Have your battery load tested at auto zone if chatrrge rate is within range.

Oct 14, 2009 | 1995 Mitsubishi Diamante

Not finding what you are looking for?
1997 Mitsubishi Diamante Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

70374 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...