Question about 1988 Mazda MX-6

1 Answer

I,LL BE DRIVEING DOWN THE AND IT WILL LOSE POWER

I,LL BE DRIVING DOWN THE AND IT WILL LOSE POWER WHEN I PUSH THE GAS IT ALL MOST GOES DEAD I JUST PUT A USED MAP SENSOR ON IT COULD IT BE THE THE MAS AIR FLOW SENS0R DAVID

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 239 Answers

Did you make sure its not the fuel pump. the mass air flow sensor would have set of the check engine light. try putting in a new map sensor never put a used map sensor in a car.

hope this helped.
please rate good.

Posted on Mar 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When driving if i push the gas pedle to the floor what would cause the car to slow down and the RPMs to go up ?


automatic i assume? the trans could be slipping if trans fluid is brownish red and smells kinda like burnt catpiss that is an indacation . if someone tells you its slipping and needs to be replaced put new trans filter and fluid change first i have had alot of success with tranies just doing that and its relatively cheap

Jan 03, 2015 | Cars & Trucks

1 Answer

Losing power while driveing like


check the fuel regulator and fuel pump. also check the filter for the fuel.

Jan 14, 2014 | Ford Explorer Sport Trac Cars & Trucks

1 Answer

I left my lights on last week. After getting a jump I started to lose power. Now it seems to be running on only 3 cylinders( 4 cylinder, 89 Nissan Sentra) and when I push too far on the gas it goes way...


Check your coil, check the cap and rotor for wear have the battery checked for low voltage or a dead cell and have the alternator checked.

May 17, 2010 | Cars & Trucks

1 Answer

When driving cluch goes in when driving the reves


Sounds like you need a new clutch. At a stand still put the car in third and try to get it to move. If you don't stall out you need a new clutch.

Apr 07, 2010 | 2000 Ford Focus

1 Answer

I was driveing my 88 gmc jimmy the other day and i


Try replacing the fusible links down by the starter. There are 2 and they look like a round rubber plug. Cut them out and splice the wires together. If they aren't there check the wire splices for corrosion. Use shrink tubeto cover the splices. Hope this helps.

Jun 25, 2009 | 1988 GMC Jimmy

2 Answers

Idles rough upon start , goes dead when letting up on gas.


If the bat went dead and was disconnected it can take 25 to 50 miles of driving for computer to reset sensors and controls. Sounds like MAF Sensor maybe reading different than when it was first driven. Did you drastically change climates or altitudes, New readings from when it originally was put into service. Slight changes in temp, alt and other variables gradually reset, if driving does not improve within 50 miles it will need diagnostics.

Jan 06, 2009 | 2002 GMC Yukon Denali

1 Answer

Start with gas but shuts off when you let off


buy a couple bottles of gasline antifreeze and put them in the tank and try it again.

Robert

Sep 25, 2008 | 1992 Toyota Camry V6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

160 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...