Question about 1993 Chevrolet G20

1 Answer

I have a 93 g20 chevy in a very good shape, last week starts to make a sound (trrr)and turns on the abs ligth, I turns the switch off and on again and it fix the ligth off. could be the abs module, or a sensor?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 20 Answers

That sounds like the ABS pump. If you have 4 wheel ABS that pump has a history of problems Leave it alone if its working now. Pump is very expensive.

Posted on Mar 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1992 Chevy G20 Van wont turn over.


Some people say "it won't turn over when they mean it cranks and won't start. If you turn the key and there's no noise, turn on the headlights to see if they are bright. If so, battery is probably o.k. If it won't crank, the problem is in the ignition switch, transmission safety switch, or the firewall connections. You have to check point to point.. If it cranks and won't start, It's either spark or fuel. More info needed.

Dec 30, 2014 | 1992 Chevrolet G20

1 Answer

93 chevy g20 have speedometer cable


The speedometer cable should not have anything to do with changing the ball joint. it goes directly to the transmission on a 93. your grinding sounds like either someone didn't get the bearing back in the hub right or loose bolts on the wheel ..

Apr 05, 2014 | Chevrolet G20 Cars & Trucks

1 Answer

Where is the brake light relay on a 1995 chevy van G20


brake light dont have relay only fuse brakes are hot at all times on gms. in goes from fuse to brake pedal switch to hazard turn signal switch then to brake lights. ck fuse if good go to pedal switch if good go to turn /hazard switch the turn signal hazard brake all use same wire to lamps.

Aug 04, 2012 | 1995 Chevrolet G20

1 Answer

When i turn on the air conditioner it breaks my fan belt..g20..93 chevy gladiator 350


replace ac compressor,,they will lock up in some cases,,causes the engine to not even turn over,,plz replace ac compressor ,,try to take belt off see if it turns free by hand!

Mar 13, 2012 | 1993 Chevrolet G20

1 Answer

Bad abs motor on a 93 chevy g20


are ya sure its usually wheel sensors

Feb 14, 2012 | 1993 GMC Suburban

1 Answer

My 93 chevy s10 blazer will start most of the time,but it will go for weeks without problems,then it desides it needs a break and will not start. it will usally start once but after you shut it off it will...


when 1st turning the key to the on position with door or window open, you should be able to hear the fuel pump (in the tank) run for a few seconds (again just key on - don't start or crank engine over) verify that the sound is there before each cold start attempt - if not there and engine won't start - you can try kicking or hitting (rubber mallet) the bottom of the fuel tank ...... what I am getting at is a bad fuel pump - you want to make sure - expensive repair

Oct 18, 2009 | 1993 Chevrolet S-10 Blazer

1 Answer

Abs panel light comes off and on while driving


I recently had the same problem, and it was the brake switch. had it replaced, and was fine for a few weeks, then the problem started again....it doesn't affect anything so i left it alone this time, and just deal with the annoyance of the light.


Oct 09, 2009 | 1993 Chevrolet G20

1 Answer

Will a 1993 chevy van G20 series trani w/OD fit in a 1984 chevy van G20 series w/out OD


93 is made to be mated to a fuel injected model with ecm that controls tranny,84 is still old school! best bet have old 1 rebuilt!

Apr 11, 2009 | 1984 Chevrolet Chevy

4 Answers

2001 Chevy Tahoe with ABS & Brake light on.


I hope you have the problem fixed by now, but, it is the ABS control under the truck. You need to go under the hood and open the fuse box and disconnect the 60 amp fuse for the ABS, this will turn it off before it burns up. This however will also cause the traction assist off light to stay lit all the time. To the fix the problem you can pay tons of money ($700 or so) to have the dealership install a ABS control and the problem will happen again over time. Or, remove it yourself, go on ebay and ship it off to a guy who repairs them for about $150 and you will never have the problem again. Also, if you wrap your cable ends with plastic and protect them good, you can still drive you truck while the part is being worked on. It takes about a week.

Nov 12, 2008 | 2001 Chevrolet Tahoe

1 Answer

Serpentine Belt chevy g20


hardest part is to remember how to rout the belt theres a place u can put a 1/2 inch or 3/8 ratchet on the tensior to make the belt slide offf

Jun 09, 2008 | 1993 Chevrolet G20

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...