Question about 1994 Ford Crown Victoria

1 Answer

SIX GARAGES DID NOT HAVE A SCANNER. i FOUND ONE AT AUTOZONE BUT I CAN'T AFFORD $126.00 TO BUY ONE AND THEN TRY TO BUY PARTS. THANKS FOR YOU HELP ANYWAY.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 101 Answers

Jc witney has a reader 4 like 20 dollars or check e bay

Posted on Mar 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2001 cavalier i have loss of power and it shuts off when car reaches operating temp


This is a known issue. You need to hound your dealer to get this fixed. A work friend of mine has this problem and eventually he just asked them to replace the car even though he had owned it for more than two years. the problem started six months in and he spent more time in a courtesy car while they tried everything to fix it. They replaced pretty much everything in the engine bay sensors. You might be able to get them to identify what needs fixed and then pick up a used one at a junk yard store where they will routinely disassemble working parts from cars. A local garage should be able to fit the part or parts.

Apr 14, 2014 | 2001 Chevrolet Cavalier

1 Answer

The boot that covers the "CV Joint" has been detached.


When the rubber boot tears/woreout it allows the grease from the cv axle to be thrown out. The axle will not last long at highway speed. You can buy a temp boot but they do not last long.If you can do it yourself.Go to a parts store like autozone and get the complete cv axle.It is a complete rebuild with enter and outer boots. Or buy the parts and take to a garage.If you can afford it do both sides..

Oct 22, 2012 | 1998 Nissan 200SX

1 Answer

2005 Mitsubishi montero limited. Abs and traction control light is on and no codes found with scan tool. Pads and rotors are good. Any ideas on how to repair and get these working again? Thanks mark


TRY BETTER SCANNER THOSE LITTLE SCANNERS AT AUTOZONE OR OTHER PARTS HOUSE'S USUALLY DONT DO ABS OR TRANSMISSION CODES OR DATA NEED A BETTER SCANNER IF LIGHT IS IN THEN THERE IS A CODE OR MALFUNCTIONING IGHTS BUT THAT IS VERY UN COMMON

Aug 08, 2012 | Cars & Trucks

1 Answer

I have 1991 corvette 5.7 liter.


The Code means there is a problem in the inflatable restraint system.
The most common problem is a sensor on the right front part of your car. Seems A/C moisture drips on the part and connector gets corroded.

You can try cleaning the pin connector, but may still need a part. Before buying parts, see if Autozone has a scanner for this section of the car. It may require a collision shop or Dealer to fix.

Jul 10, 2012 | 1991 Chevrolet Corvette

2 Answers

My engine light is on, I have a 2002 chrysler sebring


Engine light is usually actuated by oxygen sensor, have it checked and replaced if necessary, if sensor is ok, then you might be running a bit too rich. might be time for a tune up depending on when you had the last one done, reset engine light with scanner.

Aug 23, 2011 | 2002 Chrysler Sebring

1 Answer

Po240 code came up when I did the key trick. Autozone got the same and so did the garage which cost me $55 for the computer set up. The only thing I found out was it wasn't the O2 sensors for $55. I need a...


Try this before buying anything. (seeing this alot lately) Run tank down to near empty and have Autozone reset the light then fill with a good brand name fuel. Cheap fuel/gas going around is triggering false O2 sensor warnings. (Had 2 this week alone)

Apr 22, 2011 | Dodge Caravan Cars & Trucks

1 Answer

Hello, we found a 1973 Ford Consul L 2000 and it was almost untouched, they kept in a garage since 1975. We changed every single part which needs to be changed with its original and made it work after 2...


Try going to www.autozone.com You can register for free and get access to shop manuals for the car. If that doesn't help get a copy of a Chiltons' manual for the car. You can either buy a copy or check your local library for one.

Feb 18, 2011 | 1978 Ford Granada

2 Answers

Service engine soon light


You need to ge a scanner hooked up to see what error your computer has found. Most auto parts stores will do this for free, but you get little to no information about your code. Start with this. A good garage may be better help.

Feb 18, 2011 | 1999 Cadillac Escalade

2 Answers

How do you turn off service engine soon light


figure out why the codes are on in the first place(get those problems fixed), then un-hook the battery for 2 minutes, and the light will be off(this resets the computer).
If the light comes back on, then you have a problem/more problems!
Good luck.
Hope this helps!!!

Jan 21, 2011 | 2002 Chevrolet Blazer

2 Answers

My check engine light has come on. The vehicle has 107k miles. What should I be looking for


The only way to know is to get a scanner hooked up to see what error the computer has found, and go from there. Some auto parts stores will do this for free.

Oct 12, 2009 | 2002 Chrysler Town & Country

Not finding what you are looking for?
1994 Ford Crown Victoria Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...