I recently had the car jumped, then changed the battery in a 1998 Chrysler Cirrus LXi and the ABS light is now on. I read on the internet that this is a common occurence with this car , but now I can't find the website where I read this. What do you know about this issue?
I have the same problem. If you look at either wheel there should be like a gear. If basically pops off. However you cannot put it back on. You have to buy a new piece. You have to replace the whole drive axel if it is on your drivers side. I am not sure what happens if it is your passenger side. You have to replace all the transmission fluid. Buy a book. It helps a lot.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
This is the short story.The transmission sends a signal to the ECM that sends a signal to the BCM (This is what locks the doors) The ECM also sends that signal to the ABS. When the ABS doesn't sense a signal from the wheel sensors, the ABS light comes on. Have the codes checked. Let me know. Randy
ok we changed the crank sincere and still don't have any spark to my plug's and everyone is telling me different things checked the fuses and the fuel pump is working . it is a 1995 Chrysler cirrus lx 2.5 V6 please help
Are the fuses good? With the car off and the interior light on, if you try to operate sunroof, does the light dim? If yes, motor is trying to work but stuck. If light stays the same then motor not getting power. Fuses, wiring, bad switch, loose connection. Have to play detective.
There's a small possibility that mechanical cables or pulleys broken stuck, or worn out. Sunroofs look simple but they are very complicated!
Had the same problem on my 1999 cirrus lxi. Replaced the output speed sensor on the tranny and topped off the tranny fluid... cleared the check engine light and the cirrus ran great. Caution...the output speed sensor reqires removal of the front left tie and plastic weatherproofing to replace. once you find it's locvation, the replacement is relatively easy.