Question about 2000 Ford Focus

1 Answer

I have a 2000 ford taurus DOHC engine, auto trans. Have a sound from the left rear that is just like metal to metal brake - however it has made this sound before and after shoe and pad replacement. Could it be that there is a bad wheel bearing back there or should I be looking at something else?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 101 Answers

It could b a wheel bearing or the drums or rotors may be bad and damaged your brakes hope this helps

Posted on Mar 03, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How I to solve a P1237 Code ?


I would start by making sure the harness was not pinched during the install of the tank. I believe the FPMD is under the rear right seat or on that side, in the trunk.

Jul 29, 2014 | 2000 Ford Taurus

2 Answers

Break noise after changing tire


Question, you replaced tire on same rim? did you torque to specs? possible over tightened, possible coincidence and brakes are metal to metal.

Jun 03, 2014 | 2000 Ford Taurus

1 Answer

1999 ford taurus.....wont go into any gear..is it the transmission?


if the shifter wont move with brake pedal pushed ck , shift interlock,brake pedal switch,and key interlock. if the shifter moves and trans does nothing ck cable underhood at trans for operation if working yes you have trans problem . ck fluid to see level or if burnt fluid will smell real bad if low trans wont work right.and a trans can fail with out setting any engine or trans codes.so ck engine light wont come on. there is some times a release by the shifter a small cover you pull off and stick a key or small screw driver in slot and shifter will move.

Jul 15, 2012 | 2000 Ford Taurus

1 Answer

I replaced the rear passanger wheel cylinder on my 2000 ford taurus and bleed the breaks from right rear to front drivers side and still have no breaks why


was the wheel cyl leaking? make sure there are no other leaks anywhere i see rusted out line on these a lot check down left side of undercarage fuel lines and brake lines run along there .if you have abs you should only have to bleed rears the front are on different valves no air can get in from a rear leak.If no leaks anywhere master cyl most likely

Nov 30, 2011 | 2000 Ford Taurus

1 Answer

2000 taurus DOHC engine work in a 1999 Taurus DOHC car


wikipedia has great info on the ford engines.
Also look for sites that talk about taurus and their engines and putting them into rangers.
Cannot remeber the exact.

Jan 04, 2011 | Ford Taurus Cars & Trucks

1 Answer

Where is the orfice tube on a 2002 ford taurus 3.0l


If you are talking oil and or trans then those tubes are located to the left and right rear of the engine as you face the front of the engine, Trans is to the left rear and oil to the front or right side of the engine, Keep in mind that if you have a front wheel drive engine then the front of that engine is facing the passengers side wheel well or the right front tire of the car.

Oct 23, 2010 | 2002 Ford Taurus

1 Answer

Can't find the EGR sensor on my 2000 taurus. An auto store showed me a picture of where it is but it's not there. Where the freak is it?


depending on the size engine most are located under the plenum or near the left rear of it.. Of course the are 4 EGR items on this Ford. Valve, solenoid, Relay, & Manifold switch

Jul 28, 2010 | 2000 Ford Taurus

1 Answer

The 2000 ford taurus Transmission are durable??


Yes I think so. I own a 2000 ford taurus 3.0 DOHC i now have 270,000 miles and havent had a problem with the trans at all.

Jan 31, 2010 | 2000 Ford Taurus

1 Answer

Rear brake lines 99 ford taurus se


most of the time the auto parts can give you the right length.but if i had to gess your looking at 6to 7 feet long 8 ft at the most. it would be a good i dear to re place the line going to each wheel to . because those will be the next one to go good luck

Apr 19, 2009 | 1998 Ford Taurus

3 Answers

How to locate thermostat on a 2000 taurus se 3.0l duratec dohc


on ataurs with a duratec the thermostat is on the bottom radhose underneath the car. you will see a little housing near the radiator underneath the vehicle. they are a bit of a pain to get at

Jan 16, 2009 | 2000 Ford Taurus

Not finding what you are looking for?
2000 Ford Focus Logo

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...