Question about 1984 Toyota Pickup Deluxe

1 Answer

1994 Toyota Truck 4x2 Blower not working

My blower stopped working in my truck. It got to where it would come on occasionally at random, but now it doesn't work at all. I checked the fuse, but it's ok. I took the dash out, but I don't know where to go from here. I can't figure out how to get the switch out to check it, or what I need to check from here. Thanks in advance.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,533 Answers

Blower motor is normally on passenger side under the dash and the other place is under the hood on the passengerside also up against the firewall if there is a library near you you can get information from there for your truck but if it stopped working altogether the relay in the blower fan is gone

Posted on Mar 01, 2009

  • u090061 Feb 17, 2011

    Criminy! Don't take out the dash! I had the same problem with my 94 Toyota Truck (4x2). The blower would "act up" by running okay, then sometimes it ran slow in different settings, then stop, then work ("sort-of"), then quit (~200k miles). I removed the blower/fan assembly (three 8mm hex head screws accessed from BELOW the right side of the dash, close to the engine firewall). The blower resistor is forward of the fan, removable via two Phillips head screws (don't remove this if you have the above symptoms - the resistor is more likely bad if one or two speeds woun't work at all but the high speed does). Your issue sounds like the trouble with mine - and it's caused by worn out brush blocks. Try running the motor with 12v. applied to the terminals. Mine would run (albeit crappily) while holding it in different positions (with the motor removed) and vertically not at all (its installed orientation).
    If the motor's okay, "ohm-out" the resistor. You should get fairly low resistance readings.
    Good luck.



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Intermittant blower. sometimes works fine on all speeds. other times works fine

Could be a loose connection or corrosion. Make sure all of the connections are clean and tight. also if you can trace the wires to make sure there is not any breaks or exposed wires that could be shorting out. Double check the fuse as well to be sure it is in tight.

Dec 01, 2013 | 1994 Ford Explorer Limited

1 Answer

Blower motor stops working randomly

May be a worn out blower motor or burnt wire on resistor for blower motor

Nov 15, 2012 | Cars & Trucks

1 Answer

Want to know where the fan control switch is located 1994 chevy silverado heat blower motor just quit working hear a cliking noise when trying to put the blower motor on

i would first look at the blower motor resistor before the switch this is located be hind the glovebox. I would also have the blower its self checked out. the switchs these year truck are very good and rarely go bad

Feb 27, 2011 | 1994 Chevrolet K1500

2 Answers

My toyota t100,4by4,1994 pickup no ac, the

check the fuse first,then the motor for power,then the blower motor resistor

Jan 29, 2010 | 1994 Toyota T100

1 Answer

My 98 tahoe's heater only works occasionally, it used to be that it only worked on high and low and sometimes i would have to hit the dashboard to make it start blowing. recently it stopped working all...

try taping on the blower motor with a mallet. if it starts when u tap it, its probably the blower motor itself. if it doesnt it is most likely the blower motor resistor. let me know which one you need to find

Jan 13, 2010 | Chevrolet Tahoe Cars & Trucks

1 Answer

Dash guages all stopped working & blower motor switch stopped wo

Have you checked your relays? If a relay is shorting it will cause the fuses to blow.

Apr 02, 2009 | 1993 Toyota Pickup

2 Answers

Blower fan suddenly stopped working on 1994 Ram 1500

The blower fan fuse in a 30amp, light green in color. When the fan would not work, was there an abs light on or power windows or radio inop also?

Mar 21, 2009 | 1994 Dodge Ram

1 Answer

My heater blower randomly works and then doesn't work

Check the resistor between the wiring and the blower under you dashboard. It is a small gadget. Not an electronic resistor as in TV resistors.I don't know what kind of noise . Is it a clicking noise a whirling noise ? what kind ? If this helps please vote.

Dec 19, 2008 | 1988 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

188 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8729 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides