Original problem was the throttle posistion sensor. I ordered a new pcm- it's been programmed with my VIN and flashed. Installed no problem. Now the car won't start, crank, or turn over. It's got a new battery, and all the interior lights, dash, and keyless entry work no problem. Was able to crank with the old pcm. Visually inspected for broken fuses under dash. Is there a way to do a reset? Passkey?
SOURCE: 2003 Caravan No Crank, 3.3L
This is a bad PCM. Try to disconnect the security system first and if it still does not start then it is the PCM.
SOURCE: Cannot start 2000 Dodge Grand Caravan
No preferences as to charger, as long as it has trickle charge option (slower, but better for battery). Would like to see battery load test done by parts store to see battery condition, but a simple charge may be it. Let me know how it goes, hopefully you will have it up and running soon.
SOURCE: Dash lights, parking lights & interior lights don't work
Somebody left a wire harness unplugged. Look under the dash around the steering column, find something dangling that will fit into something else dangling. Undangle by connecting.
Or:
Take it back to whomever changed the steering sensor, their bad!
SOURCE: i have a 2003 dodge ram 1500 . I gave someone a
you tripped the factory ignition security system . you may have a reset button near the fusepanel
SOURCE: how to program a new remote keyless entry for 2002
1. Press LOCK button 5
times at 2 second intervals to resynchronize remote.
2. Insert key into the ignition switch. Turn ignition
to the RUN position (as far as you can
go without cranking
engine). Wait for ignition chimes to stop.
3. Using the working remote, press and hold the UNLOCK button on the
remote for 4 to 10
seconds.
4. Within the specified 4 to 10 seconds, continue
pressing the UNLOCK button and then
press the PANIC button ( on the programmed remote ) for 1 second and
release both
buttons. A chime will sound to indicate that the remote
programming mode has been
entered ( allow 3 seconds for chime to sound
).
5. Within 30 seconds of the chime, press and release the
LOCK and UNLOCK buttons
simultaneously then press and release just the
UNLOCK button on the same remote.
A chime will sound indicating the
remote has been programmed. Press and release
the LOCK and UNLOCK buttons
simultaneously and then press the UNLOCK button on
each new remote you
wish to program at this time. Locks will cycle after
each additional
remote is programmed.
6. Turn the ignition OFF and remove
key.
7. Test Remotes.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question
1,776 views
Usually answered in minutes!
×