Question about 1997 Chevrolet Malibu

1 Answer

Yer bangs when i goes in to gear

Yer when i put it in gear it bangs

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 166 Answers

Could be a motor mount or tran problem

Posted on Apr 02, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 dodge 2500 v-10 is banging into gear whats the problem


check gearbox oil level and condition. torque converter sounds faulty but you need to take it to a gearbox specialist

Apr 06, 2012 | Dodge Cars & Trucks

1 Answer

My 96 camry is starting just fine. When I put it in reverse, or any gear for that matter, and step on the gas it goes no where. It just revs the engine but doesn't move a inch. I was told it could be a...


Well if it was a cv joint and you put it in gear it would be banging around if it was broke. More likely a trans problem. did you check the fluid level?

Dec 31, 2011 | 1996 Toyota Camry

1 Answer

2005 pontiac sunfire 2.2 ecotec. when i put in drive i hear a loud bang and when driving has a quieter bang when shifts gears the motor mounts don't move much what could it be?


Sounds like transmission is low on fluid and gears are banging together when they shift. Probably should check the level and add to fill and hope that no damage has been done. I hope that helps you figure out your problem.

Nov 23, 2011 | 2000 Pontiac Sunfire

1 Answer

At a full stop the truck idles at about 5rpm and is very difficult to get into gear. i just got the clutch replaced and it still does it


It still does it cause yer clutch don't put yer engine at 500 rpm. Check timing or throttle position.

Apr 23, 2011 | 1995 Toyota Pickup

1 Answer

I have a 2000 s80 volvo transmission shifts fine but in park or nueteral it makes a rumbling noise goes away when put into gear. it did make a jolt and bang when i pulled out from the intersection thanks...


when you are sitting idle and you press the clutch without putting it into gear does the noise go? if so you will need to fit a new clutch kit.

Dec 13, 2009 | 2000 Volvo S80

1 Answer

2000 pontiac sunfire 2.4L twin cam. When put in drive I hear a loud bang and when driving it has a quieter bang when it shifts gears.


Check your motor mounts, it sound like your motor is rocking back and forth. You can confirm this by watching the engine while someone shifts it in and out of gear for you.

Sep 13, 2009 | 2000 Pontiac Sunfire

1 Answer

2001 2.4 automatic. problen is when put into gear


check tranny fluid if its ok,tranny need rebuilt.sorry.

Jun 05, 2009 | 2001 Pontiac Sunfire

1 Answer

1996 tahoe bangs gears after short drives on warm days


check your rear brake shoes if you had them changed recently they may not have been adjusted properly and that sometimes will cause that and also check the rear diff yoke where the driveshaft goes insometimes it get gear oil on it and harder for it turn. i would try these hints first before i take to shop

May 29, 2009 | 1996 Chevrolet Tahoe

1 Answer

89 ford bronco tranny problems


when you try to put it in gear engine off,does it roll either way when you push it?it could be a broken chain in the transfer case,or input shaft in the transfer case

May 18, 2009 | 1989 Ford F 150

Not finding what you are looking for?
1997 Chevrolet Malibu Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...