Outside mirrors won't move

probably needs a new switch.

check for broken wires in the rubber looking tube that goes from the A pillar to the door

Most likely will have to replace them
& doubt they are inexpensive,so much so,
I'm afraid to call & ask for my own

Likely to be the actuator/motor inside that has failed. Order one off eBay that offers returns an find out how to fit it. Should be job done!
If not its likely to be a more serious electrical issue good luck with that..

Position items,press set ,then #1 or #2

No owners manual ?

Helm.com --- to buy one

For mirrors you need to move the switch to the side you want

It should just pop off if you get something in behind the acctual glass and gently lever it you dont need to get the rear casing off at all. If its heated the wiring will be simple bayonet connectors easy to take off/on. Gently push the new glass into position and readjust teh mirror from the cabin as it will have moved!


Audi Performance Chip

have you checked fuses etc

You're lucky with this one, you do not have to remove the door panel to get the outside rear view mirror off.

Here's how do replace it: go here! just type this in search box,on pc. 2009 honda pilot outside mirror replacement. then click on first link, good-day !

remove trim panel, remove mirror fasteners.

Glass, Outside Mirror—Town Car

Removal and Installation

1. Push upper edge of outside rear view mirror glass (17K707) into the outside rear view mirror to expose latch release.
   

1. Using a small flat-bladed screw driver or equivalent, move latch release to released position.
   

1. Remove outside rear view mirror glass mounting back and outside rear view mirror glass from outside rear view mirror.
   

1. Disconnect heater wire connectors and auto dimmer connector, if equipped.
   

1. To install reverse Removal procedure.
   

------------------------------------------------------------
Mirror, Power—Outside Rear View
Town Car

Removal and Installation

1. Disconnect battery ground cable (14301). Refer to Section 14-01 .
   

1. Remove front door trim panel (23942). Refer to Section 01-05 .
   

Trim Panels, Door Front—Town Car
Removal

1. Snap out two door pull strap retaining screw covers. Remove screws.
   

1. Remove three screws on front and rear side and center of front door trim panel (23942).
   

1. NOTE: The following procedure must be used during removal and installation of the door armrest and trim panel. Refer to the appropriate illustrations for component and vehicle model identification.
   
   Using the Trim Pad Removing Tool from Rotunda Windshield and Moulding/Trim Removal Kit 107-R0401 or equivalent, pry the trim panel retaining clips from the door inner panel.
   

1. NOTE: Do not use front door trim panel to remove trim clips from door inner panel. Replace any bent, damaged or missing push pins.
   
   Remove window regulator control switch housing from front door trim panel. Lift up housing in front and disconnect all connectors.
   

1. Disconnect wiring harness and heated seat switch electrical connectors if equipped.
   

1. Remove the door trim panel.
   

1. Disconnect two electrical connectors.
   

1. Remove nut from outside rear view mirror mounting base.
   

1. Swing outside rear view mirror (17682) toward driver door window glass to expose screw in mount base.
   

1. Remove screw from outside rear view mirror base.
   

1. Remove outside rear view mirror from front door (20124). Guide wiring and connectors through hole in front door.
   

1. To install, reverse Removal procedure. Tighten nuts to 8-10 Nm (71-88 lb-