Question about 2007 Dodge Ram Truck

Open Question

Power windows stoped working on 2007 ram

I put the windows down and now none of the switches work, can not put the windows back up and there is no fuse listed for the windows, I tried a new module but that did not work

Posted by on

1 Suggested Answer

motor1258
  • 6674 Answers

SOURCE: power window problem on 1500 dodge ram

Check wire loom coming through to door at hinge end of the door from pillar, and see if you have power going that far to switch. Not uncommon to find a worn, cracked, or broken wire in that loom where it bends constantly with opening & closing door.

Posted on Oct 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 Nissan Xterra windows do not go up or down... Firstly. My drivers side window did not go up or down and no sound. All other 3 windows worked. I took the master stwich out and examined it and plunged...


See if all the wires have power. Sometimes you have a fusible link in the wires somewhere between the fuses and the switch. If no power could be a bad ground or the wires between the door and the body. Get a test light and good luck.

Jul 07, 2014 | Cars & Trucks

2 Answers

Hyundai ix35 2012 window lock stuck. passenger window half down and cant get it to move up or down


Before you replace anything, inspect the connector pins in both the driver's door switch and the passenger door switch. If you don't find any problem with these connector pins, replace the driver's door control switch.

Sep 12, 2012 | 2011 Hyundai ix35 2.0

1 Answer

2007 Dodge Durango power window switches don't work


The master switch is bad, Just replace it and your fine

Jun 08, 2010 | 2006 Dodge Durango

1 Answer

Driver side brake light stoped working and the reverse lights stoped working


Put tailgate down.Remove screw that holds light bezel on driver's side. Pull bezel assembly out. (you will have to pull hard) There will be a pop. (Two plastic nubs that go into rubber washers, that you cannot see on back side of the bezel).It's scary the first time.Twist out bulb holder.Check top bulb if blown. Check all wiring (that you can see) for chaffing.Check (back-up) lower bulb if blown.

Dec 19, 2009 | 2007 Dodge Ram 2500 Mega Cab Laramie

1 Answer

Passenger window and lock switch not working


My sister had a similar problem out of her VolksWagen Beatle, she bought it from our aunt, and it had some problems with fuses, her windows wouldn't go up or down, door wouldn't lock, etc. go have the Fuses checked out, that would be the best bet.

Sep 02, 2009 | 2007 Dodge Ram Truck

1 Answer

The passenger side window on my 2007 mitsubishi eclipse spyder wouldn't go down using the controls. Then, when we put the top down, the window went down, but now it won't go back up. I checked the fuse,...


It may very well be the motor. It is the most common problem, as they fail, even though they might work occasionally. You need to try all switches, and realistically see if the switches pass power through to the window motor.

Aug 14, 2009 | 2007 Mitsubishi Eclipse

1 Answer

Power windows will not roll down or up


If your other switches don't work, and the master is not locked, you need a new master as it is keeping the others from working.

Aug 13, 2009 | 2007 Dodge Ram Truck

1 Answer

All windows in my ml320 STOPED WORKING AT THE SAME TIME. cOULD IT BE A FUSE?


Yup, or a relay, or a solenoid. It could also be the switch. Have you tried each window at it's own door switch, or just tried the driver's switch that has all 4 window buttons? If the other ones work, but not the driver's switch, it's a wiring issue related to the driver's switch. If None of them work anywhere, have a repair facility or dealership perform electrical diagnosis (they'll be checking powers and grounds along the wiring, from the switches, to see where the issue is after checking your fuses and circuit breakers or any pertinent relays or solenoids).

Please note: All four window motors/regulators/switches failing at once is extremely hard to believe. If the vehicle was hit by lightning, maybe, I could see that happening, but if it hasn't been struck by lightning, don't let anyone sell you multiple motors/regulators or switches.

Most likely, you've blown a fuse or relay.

Hope this helps.

Jul 10, 2009 | 2007 Mercedes-Benz ML320 CDI

1 Answer

I have a 2007 Pontiac G6 and none of my windows roll up or down


1. have window switch checked 2.unplug all window motors,3.plug one window motor up at a time to determine which window motor causes the fuses to blow. 4.the could be an electrical short inside motor,check all wires to motors to be shure that none of the wire insulation has been cut. 5.check wiring diragram and have body control computer checked.

May 12, 2009 | 1996 Ford Explorer

1 Answer

Driver window


it might be the motor cause i had to replace that on my back window cause it was really slow and didn't like to go up

Mar 19, 2009 | 1990 Cadillac Deville

Not finding what you are looking for?
2007 Dodge Ram Truck Logo

Related Topics:

262 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...