Question about 1999 Chevrolet Blazer

1 Answer

Ebrake on 99 blazer

I just bought a 99 blazer and they said the ebrake doesn't hold when on so it won't pass inspection. i took it in and they said the line had rotted out and i needed shoes. Then they said i also needed front and rear rotors and brakes and want 1400 to fix it. i have never heard any whines, screeches, or grinding on the vehicle. am i being taken for a ride or is it possible they do need to be changed? I thot there would be some sign. the brakes are a little spongy but it is not taking much to stop the vehicle.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,055 Answers

Get a second opinion
thats way too much money too fix brakes
roters 28.88 each pads 15-30 a set
emcable 30.00
and its all and easy in stall

Posted on Mar 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

By pass passlock on 97 chevy blazer


Check this site out!

http://newrockies.com/

Dec 14, 2014 | 1997 Chevrolet Blazer

1 Answer

Trk won't pass inspection. It has the code PO420. catalys system below efficieny.


My father's 99 Suburban had a similar code for Bank 2(passenger side).Change the O2 sensors before and after the catalytic converter for the driver's side(cylinders 1-3-5-7).All four sensors are in the front section of the exhaust,just follow the pipe from the driver's side manifold to find the correct sensors.

Dec 08, 2012 | 1999 Chevrolet Silverado 1500

1 Answer

MY 99 NISSAN QUEST SE SUNROOF WON'T CLOSE


you may be able to take the switch apart and clean it. if that doesn't work get two pieces of wire and use them to jump the plug and by pass it all together just to get it closed

Jul 15, 2012 | Cars & Trucks

1 Answer

99 blazer won't start, have suspicions it may be


the best way to see if it is fuel problem.take a can of starting fluid and spray a small amount in the intake.(carb or throttle body) then try to start the car. if it fires you know you have power so i would suspect a fuel pump

Jun 09, 2012 | Cars & Trucks

1 Answer

I have a 1998 dodge ram 3500 dually and I took the drivers side drum off to replace the pads & wheel cylinder & the pass-side has the e brake towards the rear of the truck & dside the e brake...


Yes the longer of the two pads go to the rear,it must go opposite of where cable enters the set up. Its done that way to insure the ebrake holds forward and backwards. Good luck

Aug 18, 2011 | 1999 Dodge Ram

1 Answer

1993 jeep grand cherokee laredo, straight 6 engine. rolls back at times when in park with ebrake on.. bought it used. has a SEVERE case of bouncing speedometer. It would appear the previous owner removed...


Whether you have a drive shaft on or not the roll back is the ebrake not properly working like it should it will need a adjustment,and as for the bouncing speedometer you will need to inspect the cable as they can wear out.

May 20, 2011 | 1993 Jeep Grand Cherokee

4 Answers

Need to reset 2007 equinox after replacing battery to pass inspection... Any ideas?


i took the battery out of an o7 Eqinox to check the washer pump. when i put the battery back in, the car won't start & now the key is stuck in the ignition. i took the battery to be tested & it is good.

Nov 11, 2010 | 2007 Chevrolet Equinox LS New Cars

1 Answer

MY 2001 CHEVY BLAZER WOULD NOT PASS INSPECTION BECAUSE IF EMISSION PROBLEMS


Its generally a Catalytic Converter. Get a cheap one and get your emission passed. I've replaced everything, tuned everything, done everything, tried every trick...When I gave up and had a $100 Cat put on, It set a record for the cleanest emissions ever. Go figure.

Aug 18, 2010 | 2001 Chevrolet Blazer

1 Answer

Parking brake wont engage


Find a good shop and see if the parking brake ratchet assy is broke. This is common on chevy.. TY

Mar 11, 2009 | 1999 Chevrolet Blazer

Not finding what you are looking for?
1999 Chevrolet Blazer Logo

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...