Question about 1998 Buick Park Avenue

1 Answer

Security reset i have a 1999 grand cherokee and put a new comp in it and it will start but only for a few minutes how do i reset the comp

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

BEST THING TO DO IS TO GET THE wire that goes to the bottom under dash to the key cylendor...THen you can have the security chip from the computer..If the computer is an exact match as in options and everything to a T engine size ect...You can swap out computers...I have before...
Dont let these ase techs lie to you....I had a computer get burnt up in my 98 regal...Got one out of the junkyard and a new key with ignition cylender and BAM I was done...Engine size ect was all the same...ALl powe r optiions all the same....
Or you pay 50$ a hr fpor most service shops (DEALERSHIP ONLY) and they will say it took 2 hrs and charge you 100-150$ its up to u which ever is easier for you...
ANSWERED BY GARY KNOWS ALL!!!!

Posted on Mar 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 99 cherokee sport and no key fob how can i reset the security system


did you read the oper.guide.
or this
http://autorepair.about.com/library/a/1h/bl903h.htm

in about 1999 the rules changed again. then again in 2007.

get the OPR. guide, or FSM or read the security page at
alldata.com

Apr 22, 2014 | 1999 Jeep Grand Cherokee

1 Answer

1999 SATURN HOW TO RESET ONBORD COMPUTER


Soft reset could do it disconneting the battery cables few minutes.

Feb 05, 2013 | 1999 Jeep Grand Cherokee

1 Answer

Jeep alarm goes off for no reason after a few minutes


IT is probably just letting you know that it has received the lock signal and has secured the vehicle. Horn beps or clearence lights flask

Feb 03, 2013 | 1999 Jeep Grand Cherokee

1 Answer

Where is the location of a ignition relay in a jeep grand cherokee 1999?


There is an auto shutdown relay in the box in the engine compartment that powers several things including the PCM.

Aug 11, 2012 | 1999 Jeep Grand Cherokee

1 Answer

Wont turn over at all lights and everything else works put new altenater on on it, starter seems fine just wont start security light started coming on a week or so ago dont have owners manual so dont know...


TRY THIS RESET FOR THE SECURITY SYSTEM.

PASS LOCK RESET GM CARS 1999 UP
1) Put the key in the ignition and turn to the "ON" position. Leave it that way for 10 minutes. After 10 minutes turn the key and take it out. Repeat this process (2) more times (3 times, 30 minutes total) This should reset the passlock system to recognize your key.

Mar 22, 2009 | 2002 Pontiac Grand Am

2 Answers

The security on my 1993 Grand Cherokee will not turn off


I may be able to help if you havent fixed it yet. I believe I had the same/similiar issue...

I would make sure all of the doors were locked with auto lock button on inside of door, then I would shut the door so all doors were locked from pressing the inside auto lock button. then I would use my key to unlock the trunk, open the trunk and close it leaving it unlocked. then i would use the key to unlock the drivers door and the security would reset... if not then unhook the battery for a few minutes then hook back up and see if that works.. glgl

Mar 10, 2009 | 1993 Jeep Grand Cherokee

1 Answer

How can I reset my Factory Alarm on my Jeep it wont run


Alarm Module Reset Procedure
NOTE: This information applies to a Vehicle Theft Security System (VTSS) that was armed when the battery was disconnected and reconnected.
When the armed VTSS senses that the battery has been disconnected and reconnected, it enters its power-up mode. In the power-up mode the alarm system remains armed following a battery failure or disconnect. If the VTSS was armed prior to a battery disconnect or failure, the system will have to be actively or passively disarmed following a battery reconnection.
The power-up mode will also apply if the battery goes dead while the system is armed and battery jump-starting is attempted. The engine no-run feature will prevent the engine from starting until the alarm system has been actively or passively disarmed.
Passive disarming of the Vehicle Theft Security System (VTSS) occurs when the vehicle is unlocked using the key to unlock either front door or the lift gate. Active disarming of the VTSS occurs when the vehicle is unlocked by depressing the Unlock button of the Remote Keyless Entry (RKE) transmitter.
Once the alarm has been activated (horn sounding, lights flashing, and the engine no-run feature), either disarming method will deactivate the alarm.
Depressing the Panic button (if equipped) on the RKE transmitter will also disarm the VTSS, but the horn will sound and the lights will flash for about three minutes as part of the Panic feature. The horn and lights can be stopped by pressing any of the RKE transmitter's buttons or driving the vehicle above 15 mph.

Jan 28, 2009 | 1999 Jeep Grand Cherokee

1 Answer

94 jeep won't start


have you tried manually unlocking the hatch to reset the security
system?? My 94 grand cherokee limited did not have a key pad to turn system on/off...i have reset it by turning the key in the rear hatch lock to the left twice...see if this works. - SmokeWrench

Aug 04, 2008 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
1998 Buick Park Avenue Logo

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...