Question about 1981 Ford F 100

1 Answer

How do you get the fuel filter cap off F100 1972 pickup

Does the filter cap screw off? i can't seem to get the thing off

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 188 Answers

Antie clockwise useuallys

Posted on Mar 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rough idle wont idle


Hi, try to clean your Idle control valve, maf sensor, fuel filter and most important1 clean throtle body, try that to start, c how you go.

Aug 26, 2013 | 1983 Toyota Pickup

1 Answer

How do i replace broken hinge on fuel door for 1999 toyota corolla


Replace fuel filter on 1999 C3500 with 6.5--Loosen the 2 screws that hold the CTIS compressor in place. Move the CTIS compressor forward towards the radiators to give yourself room. The silver cylinder with a black round cap in the center is the fuel filter assembly. Clean up the area surrounding the filter and retaining ring. Unscrew the black cap that encircles the entire assembly. Clean off all the dirt on the retaining ring and filter housing threads. Coat retaining ring threads with grease.-------------------------------------------------------------------------------
lexia3 V47

Apr 10, 2013 | 1999 Toyota Corolla

1 Answer

I replaced fuel pump , coil, pickup coil, rotor, distribitor cap, fuel filter, and fuel lines. why does it keep shuting down? had the same problem before,and the last thing i put in was the pickup coil.


I need to know if it has a carb or fuel injected. When it shuts down do you have spark check it with an old spark plug hooked to the wire and grounded to the engine. When it shuts down does it squirt gas down the carb when you move the linkage Or when you crank the engine can you see fuel going down the throttle body

Feb 16, 2011 | 1988 Dodge D-Series Pickups

2 Answers

I need "step by step" instructions on how to replace the fuel filter on my 2001 Dodge Ram 3500 pickup. Thanks !


Here you go if it is a diesel:
A. FUEL FILTER REPLACEMENT:
The fuel filter is located inside of the fuel filter housing
1. Unscrew and remove fuel filter cap at top of fuel filter housing. To unscrew, attach tool to 6-sided hex center of cap. Do not loosen cap at outer edge. The fuel filter cap is designed to remove filter while pulling up on cap.
2. Remove O-ring from cap and discard.
3. The filter is retained to cap with little fingers. Carefully pry a couple of them off from old filter.
B. FUEL FILTER REPLACEMENT:
1. Thoroughly clean inside of filter housing, cap, etc. with clean diesel fuel
2. Fill filter housing (canister) with clean diesel fuel. NOTE: If you do not do this, you will have to manually bleed air out of system later. No fun.
3. Snap new fuel filter to bottom of cap.
4. Install new O-ring
5. Apply lihgt film of clean diesel oil to cap O-ring
6. Load filter/cap into housing.
7. Tighten cap to 25 ft. lbs. torque. Do NOT over-tighten.

587abd8.jpg

Sep 03, 2010 | 2001 Dodge Ram 3500 Truck

2 Answers

My 1987 chevy truck is having problems starting and running well, what do you think the problem could be?


Could be plugs, wires, cap, rotor, fuel filter, poor fuel pressure, weak coil. Basically the best thing to do is do a total tune up and see if that cures the problem, if not then we can dig deeper.

Dec 05, 2009 | 1987 Chevrolet S-10 Pickup

1 Answer

1993 toyota pickup no power going up hills


there are several things that can cause the problems you are having. the first is ignition timing. the rest are as follows: excessive play in distributor shaft, while checking that, check distributor cap, wires, etc., faulty or incorrectly gapped plugs, dirty air filter, faulty ignition coil, brakes binding, incorrect auto tranny fluid level, clogged fuel filter, slipping clutch, egr system not functioning properly, low or uneven cylinder compressions.,vacuum leaks on or around the intake manifold, or a fault with the fuel injection or engine management system

Jun 23, 2009 | 1994 Toyota Pickup

3 Answers

Mk3 mondeo,diesel,lack of power


try your MAF which is on the intake pipe with the black box that is screwed down the sensor gets dirty and doesnt read as it should.There is a how to remove and clean on utube with an older mondeo try that

Apr 08, 2009 | Ford Focus Cars & Trucks

1 Answer

88 toyota pickup v6 wont stay running


Early Toyota fuel injection use a cold start injector, it only works when the engine is cold. It is located in the intake manifold. for the mean time you can turn up your idle by turning a flat head screw in your intake manifold counter clock wise . It could be a coolant temp switch for the injector that has gone bad also.

Mar 26, 2009 | 1985 Toyota Pickup

2 Answers

1994 Nissan Hardbody limited rpms when warm


HAVE YOUR EXHAUST CONVERTER CHECKED! IF IT'S BAD AND YOU HAVE IT REPLACED, DON'T LET THE ONE THAT REPLACE'S IT TAKE YOUR OLD ONE!!!!! IT'S WORTH ABOUT $250.00

May 19, 2008 | 1994 Nissan Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...