Question about 1995 Chevrolet Lumina

1 Answer

Wontcrank Tried a new key, fuse links are ok. cables are ok

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,055 Answers

Check the starter

Posted on Mar 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1997 Toyota Tacoma new battery, clamps,& fuses.wont turn over NO sounds when key is turned .lights are only thing working????? . What am I missing


Have you tried tapping on the starter then trying to start the vehicle may be a bad spot in starter usually if no sound when trying to start and new battery will mean the starter is no good . Starter can be found by following the positive cable off the battery.

Dec 03, 2016 | Toyota Cars & Trucks

2 Answers

Total dead no power-tried jump-then new battery-then nothing


Check you cables, see if you have a short in the grounding cable. The end grounding it to the car may have come loose. Have you ever replaced the cables? That would be my next step before you dump money into it. You know it isn't the battery so just work from there.

Nov 18, 2013 | 2004 Toyota Corolla Sedan

1 Answer

Hi! My friend has got a Jaguar xj6 1997 with a 3.2Litre engine and automatic transmission. It doesnt start. Went to work,worked just fine. Dead later on the same day. Battery ok. Tried jerking the...


i assume your car is@1997 a model/year x300 a common cause of the symptom you have is a corroded/open circuit wiring at a connector or around under the washer bottle filler white connector i think its the ok to start signal from the security/locking module located below trunk fuse box the module can also go faulty. one easy test is to switch ign on if the check engine light goes off with other warning lights. start there fault finding with the wiring etc

Mar 21, 2017 | 1997 Jaguar XJ6

1 Answer

I suspect the key switch but I have had trouble starting the truck and I have a new battery. The truck won't do anything now when I turn the key. the funny thing is that it did start one day and then the...


fuseable links are located a few inches away for each componet
starter solenoid
alternator
any other factory option that uses more than 30 amps per hour
I do think you have a connection problem or a cable internally corroded
take jumper cables and connect to the starter and compare the ohm readings
the solenoid wire can be corroded as well causing a no start and no voltage reading too

Mar 05, 2011 | 1983 Chevrolet Silverado

2 Answers

1992 Toyota Camry won't crank


Check the ground cable going from the battery to
alternator, then to chassis. Make sure there is no
rust at the chassis ground wire terminal, and that it
is very tight. The fusible link will be off the alternator
red power cable,usually, but not 100% on that car.
Good luck.

Mar 30, 2010 | 1992 Toyota Camry V6

1 Answer

Turned the key to start '99 Dodge Ram 1500, after 1 second of turning over, hand slipped & key turned off. Immediately turned key again to start, now the buzz sound of the fuel pump is lower in volume,...


Hello
The 1st thing to do is make sure the battery is not defective and that the battery post and cables are clean and free of corrosion and making a good connection, even if they seem ok clean them with a battery post and cable eyelet cleaning tool, they are available from any auto parts store for around $4.00, while u are there bring the battery with u and have it tested it is free at any of the many so called discount auto parts stores , these new sealed battery types can go just like that, one moment they crank the engine fine the next not, very common, have seen it dozens of times.

Dec 03, 2009 | 1999 Dodge Ram

1 Answer

Car shut off while driving, will not start. Code


Does the check engine light come on? If not, and the fuses are good, the computer maybe bad.

Nov 06, 2009 | 1998 Ford Escort

1 Answer

2003 Ford Ranger (Mazda B2300) won't start via starter or push


Did you remove the faulty cable and replace it with a new one? sometimes a cable can be so badly corroded it's rendered useless, as the corrosion can travel all the way along the cable, if you have a multi tester check the resistance ( Ohms ) using the top and end of the affected cable, you should get a high pitched sound when you connect both ends ( to the meter ) thewad001

Mar 31, 2017 | 2003 Ford Ranger Regular Cab

2 Answers

2003 new beetle top won't go up


Try resetting the pinch protection program. You do this by inserting the key into the drivers side door, turning to the right and holding untill the windows are fully raised. Then you turn to the left and hold untill the windows are fully lowered. This is supposed to reset the program.

Good luck.

Jul 27, 2008 | 2003 Volkswagen New Beetle Convertible

Not finding what you are looking for?
1995 Chevrolet Lumina Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

71694 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22082 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7031 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...