Question about Chevrolet Suburban
SOURCE: no air
there are 2 of them one is at the reciever dryer inside the engine compartment (its inside the low pressure side ac line) the other is inside the unit in the rear and is a different style with a cap tube attached
Posted on Dec 18, 2008
SOURCE: expansion valve location
raven 1g: Your car doesn't use an expansion valve. It uses a fixed orifice tube which is located in the smaller of the two A/C lines, just before they enter the cabin area of the car.
Just disconnect the line and pull the orifice tube out of the line. Be careful not to break off anything and leave it in the line.
Posted on May 10, 2009
try adding freon with a dye in it, sounds you have a leak,pay special attention to the a/c lines that run under the truck. notorious for having pin hole leaks,check these and get back to me we'll go from there. hope this helps get back to me Thanks Ray
Posted on Mar 29, 2010
I am in the process of doing the same procedure on my 2001 durango 5.9... condensor, compressor, accumulator, followed by both front and rear expansion valves. I pulled the rear passenger side trim off after following the pipes to the back. It looks like the expansion vale is the first component hooked to the pipes just as they come through the body into the cabin. It appears to be wrapped in a black sticky mat... I did not unwrap yet so it may not be... What are your failure symptoms? I have a slow leak and a blockage inside the system to where it cannot be fully charged without releasing pressure from the rear of the compressor. I sure hope its not in the evaporator core...
Posted on Jul 02, 2010
Tips for a great answer:
Oct 02, 2012 | 2001 Chevrolet Tahoe
Jun 27, 2011 | 2007 Chevrolet Tahoe
Jun 02, 2011 | 1996 Chevrolet Tahoe
Jun 24, 2010 | 2001 Dodge Durango
Mar 29, 2010 | 1998 Chevrolet Tahoe
Aug 28, 2009 | Chevrolet Tahoe Cars & Trucks
Aug 05, 2009 | 1999 Chevrolet Tahoe
Dec 16, 2008 | 1999 Chevrolet Tahoe
Jun 24, 2017 | Chevrolet Cars & Trucks
Jun 24, 2017 | 1996 Chevrolet Camaro
1,073 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: