Question about 2000 Chrysler Town & Country

2 Answers

Neither the front nor the rear blower moters run.

About a week ago, the only way the front blower moter would work was if it was on high, and it appeared that there was no issues with the rear blower. However, neither work now. We took it to a local mechanic, and he verified that the blower and I believe two of the relays were good. How many relays are there? The gentlemen was saying that there were possibly three, but could not find the thrid one. The mechanic also said that there was no juice going to the relays which may prove that there is either a third relay which controls them, a blown fuse, or some other wiring problem... Any suggestions?

Posted by on

  • v_dude99 Feb 28, 2009

    I apologize...I was wrong about the year... It's a 2002. All the relays appear to be good... Appears to be a possible issue in the link between the battery, and the relay center. Could this still be a resistor block, and if so...where would it be be on a 2002. It doesn't appear to be located where you mentioned



2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a 2000 cryseler girrus heat comes in the car from dash panel and from air cond . whats wrong

Posted on Aug 24, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Chrysler Master
  • 6,674 Answers

First lets deal with front blower. If all fuses checked, there should be a resistor block (which when it goes usually leaves you with high fan only) for fan located on firewall, under the hood on passenger side behind the front strut mount area. It measures 1-1/2" x 3" approx, and will have a wire connector on it. It usually pulls out, with a bit of a fight. Disconnect your battery neg(-) just to be safe before you do. Replace it, that should cure front blower problem. (about $20 at autoparts store) Ask them for "blower motor resistor pack) very common item so they should know what your talking about.

Posted on Feb 28, 2009

  • 1 more comment 
  • Mike Butler
    Mike Butler Feb 28, 2009

    Hopefully the mechanic knew about power distribution box under hood, usually near battery & tested all circuits & relays in there,

  • Mike Butler
    Mike Butler Mar 01, 2009

    On the 2002 it appears that the blower motor is in behind your glove box. It also lists a blower motor relay & resistor, but I can't confirm that right now, or get an exact location. I would try following wire harness back from blower motor, to begin with. I have seen the resistor attached to blower at connection too, so we need to confirm that. I'll keep digging, and perhaps you can call local parts stor & ask if resistor comes separate from motor, or with it, they may be able to tell you right where to look too. Caution!! If you decide to try removing blower motor or connections, remove negative battery cable, to be sure not to set off airbag accidentally.

  • Mike Butler
    Mike Butler Mar 01, 2009

    Resistor should be on passenger side, right under dash about where your feet would rest. 2 screws hold it there & connector on it.



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why does my quadra fire 1000 not lite..i checked blower moter ignighter could it be thermocouple?

Wood burning or pellet stoves create acid vapor. The vapor damages thermocouples faster than a gas stove.

Jan 17, 2016 | Cars & Trucks

1 Answer

Blower moter intermitant

blower motor is wore out, if you can strike the bottom of it under the front passenger dash and cause it to start working it is definately to blower is wore out.

Feb 11, 2014 | Mercedes-Benz E320 Cars & Trucks

1 Answer

My blower resistor is always fail, I install a new one it's work a few weeks and fail again, I install a new blower moter and a new blower resistor it's work a few weeks and the resistor fail. The...

you can get a new resistor and you have to start the blower at hi always to avoid over heating in the resistors and protect the thermal fuse, the second after you had started the blower you can select any speed.

Aug 21, 2011 | 1999 Plymouth Breeze

1 Answer

My heater motor only works on high

A bad blower moter resistor can cause the blower to default to high speed only. The resistor is
located behind the lower right side of the dash on the heater box just left of the blower moter.
The fan switch can also cause this problem, but more often then not it's a bad resistor.
Hope this helps.

Nov 22, 2010 | 2006 Chevrolet Colorado

2 Answers

The front heater/air conditioner blower stopped

First check the voltage at the front blower moter. If it has voltage then it may just need a new motor.

May 17, 2010 | 2001 Dodge Grand Caravan

1 Answer

Heater fan has stopped blowing. Just before this happened a lound droning/whining noiuse came from front of vehicle.

From you're description I'd say the blower moter has
cooked a bearing. Check fuse #1 and #2 both are 15amp. They're in the fuse block behind the coin tray
on the lower left side of the dash. They usually go first if the bl moter locks up. To do a quick test unplug the bl moter, located behind the right side of
the dash. Turn the fan switch off and replace the fuses. Plug the blower in and turn it on, if it pop's the
fuses again replace the blower moter. Hope this helps.

Mar 21, 2010 | 2003 Subaru Outback

1 Answer

While driving my 2004 Yukon with the heat/defogger on high it suddenly went off and no sound of the blower being on my windows then began to fog up. I thought it was the fuse so I changed it but the...

gms are notorious for having a bad ground too the blower moters,try running a ground from the neg side of the battery too the blower moter!!

Feb 28, 2010 | 2004 GMC Yukon

1 Answer

Blower motor 94 dodge intrepid inop

1.disconect battery
2. remove lower right undre panel silencer duct
3. remove the blower moter connector from the resistor block
4. squeeze the blower moter wiring gromment and push the gromment throw the blower moter housing cover
5. remove blower moter housing
6.romove the screws holding the blower moter down
to put back on do the steps back werds

Jan 03, 2009 | 1994 Dodge Intrepid

1 Answer

Blower fan

it sounds to me like your blower moter resister or your blower moter switch are going bad both are right under the hood next to the blower moter one has 2 witers on it the other has 4 it usuley on the pass side right near the window

Dec 03, 2008 | 2000 Chevrolet Venture

Not finding what you are looking for?
2000 Chrysler Town & Country Logo

299 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8548 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides