Question about 2008 Nissan Rogue

1 Answer

Noise when driving

I bought a 88 toyota 4X4 pickup with a 22R-E engine. when i drive this truck i get a slight kind of knocking noise in 3rd gear. then gets a little worse in 4th. then gets even worse in 5th. it goes away when i get off the throttle. but comes right back when i get back on it.it don't get any worse the faster i go. just a little louder. i can't feel it in the shifter. if i push in on the clutch it kinda goes away. any help would be appreciated.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 125 Answers

It sounds like a bad main and thrust bearing

Posted on Apr 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have an 88 toyota pickup (4x4 3L V6), and I wanted to mount 16x8 rims with 33x11.5 tires. Has anyone used this set up, and if so, have you ran into anyproblems. The guys at my local tire shop suggest...


i have due to under powered engine constant 3rd to 4th and back shifts are needed i wore out the 3rd gear in a matter of 6 months and about six thousand miles

Feb 18, 2010 | 1988 Toyota Pickup

2 Answers

5 speed manual 91 4x4 gear noise in 1,2,3and 5th gear, 4th gear no noise.


do get like a clunking sound shifting between first an reverse as you let the clutch out?.if so its probably a universal joint either the one up by the tranny or the one by the rear axle.

Nov 14, 2009 | 1991 Toyota Pickup

2 Answers

I have an 86 toyota 4x4 with the 22r motor. my


it could just be the switch,, or more likley to be the resistor burned out or the reostat? (same thing realy)

Oct 27, 2009 | 1986 Toyota Pickup 4WD

1 Answer

I have a87 toyota pick up with a 22r and 33 inch tires has promblems getting started in 4 wheel drive and driving in four wheel drive almost like it barly has any power


Your truck is geared wrong now. If you change the tire size, you have to change your gears so the engine can deliver the power needed to turn the larger tires.

Oct 01, 2009 | 1987 Toyota Pickup

5 Answers

Need to change engines


If you have a 22r carbed then all 22r carbed engines from 1981-1995 will interchange. You may need to use sensor out of your old engine however. The 20r,22r,22re,22ret all have the same mounts and tranny bolt patterns. how ever there are lot of differences. you can swap from a 22r to a 22re but you must also swap the entire vehical wiring harness to do it right. if you have a 3.0L i would keep the same engine. some people have swap to the tacoma 3.6L but that is a expensive swap not exsactly bolt on so to say. If you have a 22re then stay with the 1986-1987 22re because the newer 22re use different computers, electronics ,sensors and more.. Same story with the 22ret. I hoped this helped.

Mar 26, 2009 | 1987 Toyota Pickup

1 Answer

1988 2wd 22r toyota pickup not idling


You might check the PCV valve and grommet,I'm assuming it's EFI,if the valve isn't sealed tight it will cause the motor die at lower RPM's

Feb 05, 2009 | 1988 Toyota Pickup

1 Answer

1994 toyota truck


How many miles and has the timing belt been changed? If the timing belt broke, you won't get any spark.

Dec 11, 2008 | 1994 Toyota Pickup

3 Answers

Hello, 1986 Toyota 4X4 Truck 22R carb engine manual transmission. My son was driving it and the rear wheels locked up. Driving in 2 High mode. He got the truck pulled over to the side of the road using 4X4...


I've seen a similar issue on other transmissions where the shifter slips out of the slots in the shift forks, either due to shifter bushing wear or just general wear on tte trans. It can usually be remedied at least temporarily by popping the shifter top off the trans and resetting the forks all back to nuetral and then reinserting the shifter. It gets jammed when two forks are trying to engage two different gear sets.
On one of the 4x4 sites, they tell you how to replace the shifter bushings, cheap fix if you are lucky.
Good luck.

Dec 09, 2008 | 1986 Toyota Pickup 4WD

1 Answer

1985 toyota 4x4 pickup/22R engine


put new contact point in the disrabuter,
22R has chain not belt you can check if the chain is off remove cylinder head cover you can see on front side of the engine,

Sep 10, 2008 | 1991 Toyota Pickup

Not finding what you are looking for?
Cars & Trucks Logo

171 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...