Question about 1995 Mitsubishi Eclipse

Open Question

Trans does not shift out of 2nd gear after it warms up

95 mitsub. eclipse 2.0 non turb. automatic od unit shifts thru all gears for about15 mins then when u stop it goes to 2nd. and stays there till u park it over night . when cold it does same thing over and over feels like torc. conv.unlocks when u stop then gets stuck in 2nd.took to shop and tech plugged in scanner and # 41 code comes up and also said somthing about limp code .also said pos. solenoid unit bad .could not afford to fix at shop.so, tech sent me to afriend who gave me a used solenoid and put it on,but same prob. 15-20 run time then same result.trans does not slip and fluid is full red, not brown also replaced sensor above solennoid. same w/ od. button on or off.also heard somthing about speed sensors .help !!! thanks

Posted by on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: automatic is not shifting to overdrive

Problem solved. I found on the www the wiring diagram, corresponding to the o/d switch. I saw that there is a engine coolant temp switch (at coolant outlet of engine). the connector to it was corroded. So cleaning it,...o/d is now working proper.

Posted on Apr 02, 2009

autotherapis
  • 501 Answers

SOURCE: automatic transmission trouble

With so little info, you can only guess. Most computer controled transmission default to either second or third gear if there is an electrical problem.

The mitubishi trans has sensors on the trans that if they are hooked up wrong, it wont shift. If the fluid is full and clean, odds are you have an electrical problem. Could even be a fuse or the computer.

Hope this helps.

Posted on Aug 20, 2009

  • 1 Answer

SOURCE: transmission problem stuck in sport shift mode

I also have a 2009 Outlander Sportronic transmission with a V6 engine.
Bought it this summer ... transmission appeared fine but seemed to automatically slow down the vehicle using the engines compression whenever I let go of the gas pedal.
Now that the cold weather is upon us here in Canada, whenever I accelarate normally (not like a teenager) the transmission takes quite a bit of time to shift into second... If I rev up the engine (quick take off) it seems to help but the shifting of gears is not as smooth as I would expect it (mildly slips and kicks into second)...

The worst is when come to a complete stop ... then the transmission kicks coming down from the higher gears???

I read somewhere that this is because this transmission is a CVT type and is learning my driving habits in order to adjust itself so the vehicle becomes more fuel efficient... Not sure but if the trany is computer controlled then it must be poorly writen program...
I'm taking the car in to the dealer and will write back on the diagnostic they give me ...

Posted on Oct 21, 2009

  • 2 Answers

SOURCE: automatic transmission is stuck in 2nd gear (limp mode)

it is eletical eather a fuse is blown or the speed sensor didnt get hooked up dose spedo work

Posted on Apr 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Dash shift lite idcaters out on my 2001 mitsubishi eclipse gt spyder


For Automatic transmission problem,click the link below:---- Automatic transmission troubleshooting:----

http://howtobyme.blogspot.com/2011/11/automatic-transmission-will-not-go-into.html

---------
Automatic transmission shift lever issues?-------

http://technoanswers.blogspot.com/2012/01/automatic-transmission-shift-lever-hard.html

-----------
AUTOMATIC TRANSMISSION FLUID LEVEL? --

http://schematicsdiagram.blogspot.com/2011/07/how-to-check-automatic-transmission.html

--------------

AUTOMATIC TRANSMISSION FLUID AND FILTER?

http://schematicsdiagram.blogspot.com/2011/07/how-to-change-automatic-transmission.html

-----------
Transmission fault light on car dash?

http://schematicsdiagram.blogspot.com/2011/12/transmission-fault-light-on-car-dash.html

--------
Transmission shifting problem?

http://schematicsdiagram.blogspot.com/2012/01/transmission-shifting-problem-on-toyota.html

--------
Transmission Slips out of 2nd gear?

http://repairhelpcenter.blogspot.in/2012/02/transmission-slips-out-of-2nd-gear.html

-----------
OD light flashing and transmission fluid leaking?

http://repairhelpcenter.blogspot.in/2012/02/od-light-flashing-and-transmission.html

----------
Why Transmission fluid leaks near radiator?

http://repairhelpcenter.blogspot.in/2012/02/transmission-fluid-leaks-near-radiator.html

----------
Transmission fluid leaking?

http://technoanswers.blogspot.in/2012/02/ford-windstar-transmission-fluid.html

-------------
****** wont go in reverse?

http://technoanswers.blogspot.in/2012/02/dodge-neon-wont-go-in-reverse.html

-------------
Automatic transmission will not go into reverse?

http://technoanswers.blogspot.in/2012/02/dodge-automatic-transmission-will-not.html

----------
Transmission is making buzzing noise?

http://technoanswers.blogspot.in/2012/02/transmission-is-making-buzzing-noise.html

-----------

This will help.

Thanks.

Feb 19, 2012 | 2001 Mitsubishi Eclipse Spyder

1 Answer

Shifting in higher gears


For Automatic transmission problem,Check the list of help links below.click the link below:----Automatic transmission troubleshooting:----

http://howtobyme.blogspot.com/2011/11/automatic-transmission-will-not-go-into.html

---------
Automatic transmission shift lever issues?-------

http://technoanswers.blogspot.com/2012/01/automatic-transmission-shift-lever-hard.html

-----------
AUTOMATIC TRANSMISSION FLUID LEVEL? --

http://schematicsdiagram.blogspot.com/2011/07/how-to-check-automatic-transmission.html

--------------

AUTOMATIC TRANSMISSION FLUID AND FILTER?

http://schematicsdiagram.blogspot.com/2011/07/how-to-change-automatic-transmission.html

-----------
Transmission fault light on car dash?

http://schematicsdiagram.blogspot.com/2011/12/transmission-fault-light-on-car-dash.html

--------
Transmission shifting problem?

http://schematicsdiagram.blogspot.com/2012/01/transmission-shifting-problem-on-toyota.html

--------
Transmission Slips out of 2nd gear?

http://repairhelpcenter.blogspot.in/2012/02/transmission-slips-out-of-2nd-gear.html

-----------
OD light flashing and transmission fluid leaking?

http://repairhelpcenter.blogspot.in/2012/02/od-light-flashing-and-transmission.html

----------
Why Transmission fluid leaks near radiator?

http://repairhelpcenter.blogspot.in/2012/02/transmission-fluid-leaks-near-radiator.html

----------
transmission fluid leaking?

http://technoanswers.blogspot.in/2012/02/ford-windstar-transmission-fluid.html

-------------
****** wont go in reverse?

http://technoanswers.blogspot.in/2012/02/dodge-neon-wont-go-in-reverse.html

-------------
Automatic transmission will not go into reverse?

http://technoanswers.blogspot.in/2012/02/dodge-automatic-transmission-will-not.html

----------
Transmission is making buzzing noise?

http://technoanswers.blogspot.in/2012/02/transmission-is-making-buzzing-noise.html

-----------

This will help.

Thanks.

Feb 09, 2012 | 2000 Isuzu Rodeo

1 Answer

Transmission is shifting hard and slow to pull on a 95 silouette also makes clucking sounds while accelerating


Shift suddenly become very hard. When going from park to either reverse or drive it slams into gear. 1-2 and 2-3 shifts are also harsh. All gears seems to work. Problem may be intermittent: Check TPS for smooth and linear electrical response over the entire range of motion. If not, replace.

Extremely harsh shifts from P or N, normal shifts at WOT: EPC (Electronic Pressure Control) solenoid failed. Easy fix in pan. Fix as soon as possible or hard parts will eventually break.

No 1st or 4th available; trans shifts 2nd to 3rd by itself in D or OD and locks the converter : ShiftA solenoid failed. Easy fix in the pan. Or a wiring problem from PCM to trans.. or PCM.

Car goes into gear but feels very sluggish like the brakes are dragging, but it will roll easily (starts out in 4th gear), you manually shift to 2 to get it moving, once it's moving you put it back in OD and the car shifts 3rd to 4th on its own and locks the converter at the appropriate time: ShiftB solenoid failed: Easy fix in the pan. Or a wiring problem from PCM to trans.. or PCM.


Mar 05, 2010 | 2002 Oldsmobile Silhouette

1 Answer

The automatic transmission skips the middle gears when shifting from 1st gear does this have a tv cable i can adjust and if so how


There is no TV cable, your transmission is electronic. Before guessing at transmission problems, check the fluid level (car warmed up, engine running in Park on level ground) and have the PCM scanned for trouble codes FIRST.

Secondly, put a line pressure gauge ( visit a local trans shop) on the pressure test port and go for a drive to verify proper line pressure. Base pressure at idle in P,N,OD should be around 70psi and around 140psi in R. Max line pressure should be at least 190psi at WOT in 1st or 2nd, 225psi is optimum. If base pressure is low, trans or pump is worn out. If max pressure is low, check EPC solenoid. If reverse is slow to engage, and line pressure does not come up to at least 130psi in reverse, replace the boost valve with a Transgo 0.490" boost valve (easy fix in pan).

1-2 shift does not happen at WOT until you let off the gas: Best case: try replacing the TPS. Middle case: leak in the 2nd gear apply circuit (servo assembly or 1-2 accumulator). Doublecheck by using the pressure gauge and watch for a big drop when the PCM commands 2nd gear. Worst case: poor line pressure rise.

1-2 Shift shudder at WOT; delayed or abnormal 1-2 shift; There's a problem ONLY on the 1-2 shift: 1-2 accumulator piston cracked or stuck cocked in the bore. Check the yellow spring inside the accum housing for breakage. Also, if the accumulator housing walls are scored, the housing must be replaced. Easy fix in the pan.

1-2 shift is delayed and harsh, may not shift into OD: Check TPS for smooth and linear electrical response over the entire range of motion. If not, replace.

Soft shifting, gradual performance degradation: Poor line pressure rise due to leaking boost valve, clogged EPC filter screen, failing EPC solenoid, or worst case: leaky seals throughout. Transgo HD2-C kit fixes first two without removing trans. Seal restorer may fix last problem, but probably R&R. Also try a transmission flush with BG brand products (Firestone stocks it).

1-2 or 2-3 shift is slow/soft above part throttle: Trans is on its way out. R&R.

Good luck and hope it's a simple TPS probelm.

Feb 01, 2010 | 1994 Chevrolet S-10 Blazer

2 Answers

95 GMC Jimmy 4L60E no 2nd or OD 4L60E


do u have any trouble codes for the trans? u need to find out to see if a shift solenoid (possible 2-3) has failed.

Apr 15, 2009 | 1994 Pontiac Firebird

1 Answer

Shifting lever doesnt lock


Likely the shift detent mechanism is broken. It's inside the unit and can be reached by removing the trans pan. It should be just inside where the shift lever goes through the case.

Mar 17, 2009 | 1995 Jeep Grand Cherokee

2 Answers

95 GMC Jimmy 4L60E no 2nd or OD 4L60E


You might want to try this if its got a kick down cable unhook it from throutle body and pull it out as far as you can and let it snap back, do this a few of times, sometimes a valve gets hung up inside valve body of trans. and won't let it shift. If that don't help you may have to pull pan to dislodge it if thats the problem. chk. the plug on trans. (Its a 4 wire white plug) with test light with key on to see if there is power down there one will be hot, thats for overdrive, now on top of intake in front throutle body there is a sending unit that looks like a temp. sending unit with a 2 wire plug on it that sends a signial down to that plug when engine gets to temp. to let it shift to overdrive. Maybe this will help, or give you some ideas.

Mar 02, 2009 | 1995 GMC Jimmy

1 Answer

Jumps into manual 2nd gear


When was last fluid & filter change?

Nov 22, 2008 | 2000 Dodge Stratus

Not finding what you are looking for?
1995 Mitsubishi Eclipse Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...