Question about 1991 Mitsubishi Mighty Max

1 Answer

Computer in 1991 mits pick up

Hello, i am trying to find where the computer is located at in the 1991 mits, i think it has gone out or something, it will not start and i either need a distrubtor cap or the computer.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I recently replaced the ECU in my 91 mighty max. If you remove the glove box you will see it on the right hand side.

Posted on May 20, 2009

  • tswilson May 20, 2009

    Also, the computer going out is a common problem for this model. It is likely that this is your problem.



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

WHERE IS THE Electronic Ignition Module in 1991 Mits. Montero located

The module is in the distibiutor on the 3.0 engine if you have the 3.5 it would be the crank sensor to the ECM with cam sensor also. Have you checked to see if the timing belt is still intact and moving the camshafts. I have also seen a lot of ecu issues that cause the same thing. But I would start with simple steps Check fuses and connections first.

Sep 28, 2016 | 1991 Mitsubishi Montero

1 Answer

My seat belts don't work do you think it is a fuse

Your cars seat belt control module, located under the front passenger's seat, might've gone bad. Have it checked out. It could also be something as simple as a fuse. Check them also.

Dec 30, 2010 | 1991 Honda Accord

1 Answer

How big of a job is mit to replace a starter in a

It is pretty simple, please call 4196891712 I will help you via phone to replace your starter.

Jan 24, 2010 | 2007 BMW 525xi Sedan

1 Answer

Where is the ignition module located at on a 1991

The ignition module is located inside the distributor below where the rotor is, it is held down with two or three screws to the distributor plate. There are two components in there the coil pick up is the device that picks up a signal from the distributor shaft, the other component is the ign. module.

Nov 17, 2009 | 1991 Honda Accord

1 Answer

My 1991 toyota pick ,will start but shut off ,

I would check out the Mass Air Flow Sensor. Located on top of the air filter box. If the sensor is bad and computer doesn't see air going into the engine, it will automatically keep the engine from running. Try pulling the engine trouble code to confirm is problem.

Oct 11, 2009 | 1991 Toyota Pickup

1 Answer

My vehicle stalls out after initial start up we think due to improper communications involving the vehicle's theft alarm in the computer system. Can we use a similar year of vehicles' (1991) computer as a...

Nope, body styles and system packages differ as well as engine accessories, however to confirm this get both car info goggle auto computers and pick a site that shows both car computers and see if they both have same part numbers

Jul 19, 2009 | 2002 Chevrolet Blazer

1 Answer

My 1991 plymouth acclaim went dead and won't start. I dont't have fire to the distributor?

I had the same problem with my 1991 Plymouth Acclaim 3.0 liter engine. Check to see if your SBEC (computer located next to car battery) has gone out. Replacing it should solve your problem.

Jul 06, 2009 | 1991 Plymouth Acclaim

1 Answer

We are trying to locate the oil pump on our 1991 Dodge Caravan - 3.3 V6. Indicators seem to show that it has gone bad.

Sorry did not see the engine info before
You need to remove the oil pan to get to the oil pump
once pan is off you will see a tube with a screen that's the oil pump pick up tube, the pump is on the end of the tube.

Jan 13, 2009 | 1991 Dodge Caravan

1 Answer

Hello i have a 91 toyot camry 2.0 engine,it stop on me and it will not start.

dear shame,
try replacing the distributor cap first, it is easier rather than replacing the trans, i dont really think that your problem has something to do with your trans. good luck!

Dec 21, 2008 | 1991 Toyota Camry

Not finding what you are looking for?
1991 Mitsubishi Mighty Max Logo

Related Topics:

352 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

77544 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides