Question about 2004 Dodge Stratus

1 Answer

No power to stereo or power locks

I recently installed a new stereo into my 2004 dodge stratus and after doing so the stereo will not turn on and the power locks will not work. I tried putting the factory stereo back in but it too doesn't work. Checked all the fuses and they seem to be fine. I also resetted the battery for about an hour and that did nothing! I can't seem to figure out what the problem is. I know for sure that I installed the stereo correctly so it has to be a problem with fuses/relays/battery. Can someone help me?

Posted by on

  • Anonymous Feb 27, 2009

    Yes I've checked the fuses in the dash as well as the fuse box in the hood

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 6,674 Answers

Checked all fuse in dash are, as well as power distribution box under hood?

Posted on Feb 27, 2009

5 Suggested Answers

keemo68
  • 1263 Answers

SOURCE: 2004 Dodge Stratus A/C Fan Relay Switch

ok first the fan relay should be located inside the elecrical box. this is usually located on the drivers side under the hood. next even you have only one speed when you turn the switch it's because the reostat is bad it is located in the fan motor housing. hope this helps.

Posted on Aug 28, 2008

  • 2 Answers

SOURCE: How to put a cd player in place of factory stereo in 1994 dodge dakota. Need wiring diagram in color.

i had this problem to, do not hook the ground wire from truck to your radio. use the braided wire that hooked to your old factory radio by inserting a bolt into the braided wire and ground from your new radio.
then check fuses one more time and you are good to go.I didnt think this would work but it did..

Posted on Dec 27, 2008

  • 2 Answers

SOURCE: how would i add amp and sub to a factory stereo system

you have to goto best buy wal mart or somewhere like htat they sell an adapter that converts speaker wire to rcs its like 20 to 30 bucks what i did is take the left rear speaker and direct wired it to the right side then conected the converter box to the left rear wires and then you can go from there with your rcas

Posted on Feb 14, 2009

c17hydro
  • 2984 Answers

SOURCE: 2004 Dodge Stratus air filter

Open the big plastic box....there's the filter

Posted on Mar 05, 2009

polarcycle
  • 1392 Answers

SOURCE: 2004 DODGE STRATUS 2.7L, Location of Crankshaft Position Sensor?

it is located on the right side of the motor, in the trans area. Actually in the bell housing.

Posted on Jun 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2004 Dodge Stratus (4cyl) that idles rough (almost stalls out), dies on start up and recently had a flashing engine light (backfire error). Any suggestions? No other issues, water pump and timing...


Could be the idle air control, once these start hanging up inside, they can cause as variety of problems with idle speed (can become wildly random) or simply a failure to idle at all.

These links should help:
Where is the idle air control valve located on 2004 Dodge Stratus

2004 stratus idle air control Bing

This could also be caused by a failing ignition pack.

Jan 25, 2015 | 2004 Dodge Stratus

1 Answer

2004 dodge stratus wont start dashboard flashes bus


probably blew your fuse check them all

Feb 21, 2013 | 2004 Dodge Stratus

1 Answer

1997 dodge stratus agency alarm came on now car seems to be blocked it turns on but then turns off and the alarm keeps honking when i turn the ing switch to on position the lights,door locks,stereo and...


You need to get the alarm system reprogrammed. I don't know your personal code. It may be in the owner manual. If not, you will need to call a Dodge dealer.

Feb 15, 2011 | 1997 Dodge Stratus

1 Answer

How do i remove the 2004 dodge stratus stereo?


you have to remove the trim plate which has clips holding it in.A plastic trim removal tool available at auto stores works best,as prying with a flat blade screwdriver will damage the dash.Once that is removed,the 4 bolts holding in the radio can be removed.Pull the stereo forward and the antenna plug,and the speaker connector and the power connector have to be unplugged by pressing in the clips.

Jan 03, 2011 | 2004 Dodge Stratus

1 Answer

I need torque specs for the head bolts on a 2004 Dodge Stratus Coupe 2.4L SOHC


For 2004 Dodge Stratus 2.4L SFI SOHC 4cyl the Head Bolt Torque sequence
------------ | 10 6 2 3 7 | | 9 5 1 4 8 | ------------

Step: 1 - Torque to 25 ft/lbs
Steps: 2 - Torque to 50 ft/lbs
Steps: 3 - Torque to 50 ft/lbs
Steps: 4 - Turn 90 degreesRecheck final torque in sequence

Caution:Engine uses torque to yield head bolts (TTY) that permanently stretch during initial installation. New head bolts must be used when cylinder headis replaced or re installed to obtain proper torque specification.

Hope helps (remember comment and rated this).

Aug 02, 2010 | 2004 Dodge Stratus

1 Answer

I have a 04 dodge stratus and the dome lite and radio and data link connector and power locks and trunk dont all work.the fuse is good i put new one in and still wont work.now what do i do?


I have the same problem with my 04 stratus cant get car inspected cause data link so the cant inspect emmisons, anyway i was told it may be the bcm (body control module) if it is buy a used one from junk yard they are a little expensive. or it could be relay since fuses usually dont do so many things (dome llight, power locks, radio, data link)

Jan 31, 2010 | 2004 Dodge Stratus

1 Answer

2005 dodge stratus, both power windows on the driveer side do not work. power locks will only unlock


Most likely your switches are bad, perhaps you spilt something on them or you left your window open one night and it rained. easiest fix go to dealer and buy new switch assembley.

Jul 07, 2009 | 2004 Dodge Stratus

1 Answer

Key won't turn in the ignition


if you tap on the lock cylinder with a small hammer it may jar it enough to get it to turn.....to replace the tumblers you will need to remove the lock cylinder and then disassemble it. each tumbler has a certain number on it and will need replaced with that same number. it is easier to have it dealer or locksmith do it.

Dec 23, 2008 | 2004 Dodge Stratus

Not finding what you are looking for?
2004 Dodge Stratus Logo

Related Topics:

327 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...