Question about 1999 Oldsmobile Intrigue

2 Answers

Movano van how to rest key fob

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I have just bought a v reg vauxhall movano when i put the key in the ignition the immobiliser light goes out but the engine wont start any ideas

Posted on Aug 19, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Oldsmobile Master
  • 1,000 Answers

Elayn, try pushing the lock and unlock buttons at the same time until you hear the locks click. That may resynchronize the fob with the lock module.

Posted on Feb 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Remote key fob wont work after installing a new battery in car 1993 Lincoln mark VIII


Try replacing the battery in the key fob first. If that dosent do it, run the car battery entirely down, ( via headlights, radio, etc ) and then recharge the battery. This should rest the computer.

Apr 21, 2014 | Lincoln Mark VIII Cars & Trucks

1 Answer

CL220, fob wont open doors I can't get in the car, does this mean the battery is flat?


battery may be flat in the fob or the vehicle has forgotten the code for the fob. and will need resetting. change the battery use the key to open the door put key in the ignition. ( fob Ir old type leave fob off the key) turn to number 2 and press fob till doors lock and unlock. then its reset. dont be worried if the alarm goes off while doing this it will go off when the code is restored. if you have 2 fobs you will need to rest that one to.

Mar 17, 2014 | Mercedes-Benz C-Class Cars & Trucks

1 Answer

Door locks


No you will need to replace the battery or get another fob and have the dealer rest it.

Feb 08, 2014 | 2003 Chevrolet TrailBlazer

1 Answer

Key fob flashes but wont unlock car vectra sri130 2000


yes then when you get in turn key to number to and press the fob the locks should lock the door and the fob is rest.

Apr 07, 2013 | Vauxhall Cars & Trucks

1 Answer

Key fob not working


put key in ignition turn to number two lights on on dash. then press fob till doors locked key fob rest now.

Mar 04, 2013 | Vauxhall Cars & Trucks

1 Answer

Keyless entry remote wont progam


It will not unlock the door the first time you push the button. This only registers the key fob ID into the computer. When you press the button on the key fob, press it only once and wait for the hazzard lights to flash twice again. Then open the driver's door. The key fob will not become active until you open the driver's door.

If your hazzard lights do not flash after you press the button on the key fob, there is most likely a problem with the key fob. Either it is not the correct key fob for your vehicle, or the battery is not in correctly or the key fob is defective.

The only other advice I can give you is to have it programmed with a scan tool. This way, the scan tool can verify that the computer in your vehicle is receiving the signal from the key fob.

It can be done either way, but if the "no scanner" way does not work, the rest of the system should be checked for possible problems.

Dec 12, 2011 | 2005 Nissan Altima

1 Answer

Re-program Keys


  1. Pry open the plastic key fob with a flat-head screwdriver.
  2. Remove the back of the key fob and set it aside.
  3. Hold the front half of the key fob in your hand; turn it over so the rubber buttons touch your palm.
  4. Use your finger to gently pry the circuit board from the back of the panic button; set the circuit board aside.
  5. Stick a piece of tape over the metal connectors on the back of the panic button.
  6. Replace the circuit board, which should now rest on top of the tape.
  7. Replace the backing of the key fob and press down to snap it into place.

Hope this helped.

Feb 01, 2011 | 2002 Dodge Caravan

1 Answer

Key fob only opens drivers door


hit the unlock button twice. most fobs are programmed so you hit it once, drivers unlocks, and again for all the rest.

Jan 25, 2010 | 2004 Volkswagen Passat

2 Answers

Key will only open drivers door you have to open rest of doors manualy


Your FOB may be programmed to press once to open the driver door, press twice to open the rest. This feature is to prevent uninvited guests jumping in the car when the driver getting inside the car the same time.
Check out the FOB key setting.

Aug 04, 2009 | 1996 Mercedes-Benz E-Class

Not finding what you are looking for?
1999 Oldsmobile Intrigue Logo

Related Topics:

1,275 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...