Question about 2005 Chrysler Pacifica

1 Answer

How to remove the headlight lens 05 pacifica?

I tried to replace the headlight bulb and could not get the lens off. What is the correct way of taking it off.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 837 Answers

If I remember correctly there a a couple of nuts under the hood on each side that you have to remove and then you can swing the lens assembly out for access to the lamp socket.

Posted on Feb 27, 2009

  • Jay Glendenning
    Jay Glendenning Feb 27, 2009

    I just went and checked my pacifica .. take the two screws off on top of the headlight to release the top and
    reach under the headlight assembly between the bumper and the headlight
    and pull it gently.the clamp should release the light and you can pull
    it out

  • Jay Glendenning
    Jay Glendenning Feb 28, 2009

    If this worked for you .. Please rate me a FixYa! .. Thanks .. Crayz



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Headlight out

Open hood take out two bolts on top of headlight housing. Put a rag or tape on bumper below headlight and pop out with screwdriver. Take off rubber boot and run a child's hand inside and turn bulb and remove Use needle nose pliers if child not around Don't touch bulb with hand and install if you touch bulb wipe with alcohol

Nov 18, 2011 | 2005 Chrysler Pacifica


How To Replace Change Headlight and Bulb Buick Lesabre 2000-05

How To Replace Change Headlight and Bulb Buick Lesabre 2000-05

on May 02, 2012 | 2005 Buick LeSabre


How To Install Replace Headlight and Bulb Chrysler Town and Country 05-07...

How To Install Replace Headlight and Bulb Chrysler Town and Country 05-07

on Apr 04, 2012 | 2007 Chrysler Town & Country LX New Cars

1 Answer

How do you replace the headlight on a 2002 Daewoo Lanos

Hi there, together with providing you the solution to the problem, I also took the liberty of going one step further in giving you steps on how to remove the headlight bulb.

  • Find the hood release handle and activate it, the hood should pop open.
  • Once the hood is popped open locate the hood secondary or safety latch and release it. Then finish opening the hood.
  • Locate and remove mounting clips for any plastic shields that cover the headlight lens mounting screws or clips.
  • Some headlight bulbs can be replaced by simply grasping the bulb socket behind the headlight lens and turn it counter clockwise to remove it. This will expose the headlight bulb.
  • If the headlight bulb socket is not accessible the headlight lens may need to be remove or obstructions behind the bulb removed to gain access to the headlight bulb socket.
  • To remove the headlight lens remove all mounting screws and clips that hold the headlight lens in place.
  • After the headlight housing has been removed from it's mounts, release the headlight bulb from the headlight lens housing (turn counter clockwise) the bulb will then come out of the headlight assembly. Once removed, visually verify that the replacement bulb is exactly the same as the failed bulb before to ensure a proper repair.
  • Clean the headlight lens free from all debris to help maintain the seal from the bulb to the lens. This will keep moisture out of the lens.
  • Install the new headlight bulb by turning the retainer ring or bulb clockwise.
  • Re-install the headlight lens housing and reinstall electrical connector.
  • Re-install plastic covers.
After the job is complete turn the ignition key to the "on" position and activate the headlight switch. Observe the newly replaced headlight bulb to ensure proper operation.

Glad to be of help!!!

Jan 21, 2011 | 2002 Daewoo Lanos

2 Answers

How to change a headlight bulb in a 2006 Chrysler Pacifica

Most all bulbs today are replaced through the back of the lens assy. Youll need to look under the hood and find the light sockets. then you can turn them 1/4 turn to unlock them and pull out. New lamp should not be touched with fingers, install is same, plug new lamp into socket, insert into reflector and turn to lock.

Oct 21, 2010 | 2006 Chrysler Pacifica

1 Answer

2006 pacifica burned out headlight . how do I replace it?

Under the hood - follow the wires to the back of the headlight assembly and remove the connector. Remove the lock ring around it and coax the old bulb out - it is held in with a rubber sealing ring. Make sure the new one snaps back in the correct position. The bulb will only fit in in the same position as the old one. Reinstall the lock ring and the wire connector.

Jan 15, 2010 | 2006 Chrysler Pacifica

2 Answers

How do you replace a low beam head light on 05 pacifica driver side

behind headlight assembly there is a round lock ring directly attatched to assy. turn counter clockwise like a 1/4 turn. pull off. unplug h.light wires. wiggle and pull on bulb. replace bulb and reverse procedure

Jan 09, 2010 | 2005 Chrysler Pacifica

2 Answers

I don't know how to take off the head light lens cover on my nissan maxiuma

Probably not a lens cover at all. It's just a 1 piece plastic headlight. It you are wanting to replace a bulb , they go in from the back . Open the hood and you should be able to see where the wires to the bulb go in the back of the headlight.

Nov 06, 2009 | 1997 Nissan Maxima

1 Answer

How do u get to the low beam bulb to change it on the 2004 chrysler pacifica

Take out two screws above headlight under hood. Pull headlight forward remove rubber cap reach in with real small hands or needle nose pliers remove bulb with a twist. Insert bulb same way after you wipe it with alcohol replace rubber cap push back in and replace two screws.

Nov 02, 2009 | 2004 Chrysler Pacifica

1 Answer

Replace headlight bulb

you should not need to take housing out.

Oct 18, 2009 | 2005 Chrysler Pacifica

Not finding what you are looking for?
2005 Chrysler Pacifica Logo

Related Topics:

447 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides