- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
the timing marks are on the camshaft pulleys and there are 2 notches on each pulley> they line up with 2 marks on the engine block for each pulley> and the crankshaft has a notch that lines up with a mark on the engine block aswell> pluss the new timing belt will have white marks on it that will line up with all of the marks on the pulleys when they are in the right place so its nearly impossable to do it wrong
your timeing marks are on the block rite abouve the cams on either side and on the block in the middle but line the center mark on the teeth there is a mark not the arrow the arrow is where tdc is the mark is on teeth good luck.
The water pump is run by the timing belt.Involves the draining the antifreeze,removing the radiator/condensor fan motors,harmonic balancer,alt./ac./p.s. belts, timing covers and timing belt.Along with a new pump,a new timing belt should installed.Timing marks are critical and it should be repairer by a garage.Should take about 1 to 2 hours or so to do if everything comes apart easy.Also there is no cap or rotor,only a coil pak.Hope this gives you a better idea.
I had the same symptoms. I had to count the correct number of teeth from the crankshaft pulley to the cam pulley marks.It is a different number of teeth to each pulley.It turns out that I was off by one or two teeth on one cam.
The key way that the sprocket rides on that obviously fell out. the key way holds the sprocket in place. You can get another key way at you NAPA store or the dealer. Re-set your timing marks and install the keyway and re-install the sprocket.