I started a drag project with my truck which is a '97 ram 1500 sport 2wd short-box. right now its my daily driver, but i am looking for help with the installation of the engine and trans. the engine is a '69 440 block w/a 512 cu. in. stroker kit and aluminum heads from 440 source.com the drive train is a 727 w/3500 stall and 9.25 transaxle w/4.56 gear. my question is where can i find the proper motor mounts? i have the 5.9 L 360 stock in it now, but i need help with motor mounts/any hardware needed to stuff my big block in the engine bay and have all measurements lined up. any help would be appreciated
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Jul 2, 2010 - 15 posts - 9 authors
My brother just got a 2008 1500 and the TPMS light is on. The dealer ... Does any one know how to reset the TPMS so that the light will turn off? Logged .... Quote from: dragonslayer169 on July 03, 2010, 08:14:37 am. Awesome ..... I have having a TPS issue on the new Ram that is ticking me off. I plan to try ...
Dec 11, 2013 - 10 posts - 3 authors
So my low tire pressure warning goes off because it says the right front tire is low. ... It should reset, it may take a cycle or two but unless you need a new sensor it should be ok. ... It was automatic on my truck and it's a 2010.
You should check the engine compartment fuse box. If not there is a number of steps you can take to diagnose wiring issues. I wrote an article awhile back illustrating these steps. Please click here to view.
This code will not stall or no start of your engine, evap only work when engine is off, it is to reduce the fume your gas tank lets out to protect the o zone, but it will not pass Emission test, also could be some thing a small as your gas cap not sealing right.
It may be a bad starter or the starter solenoid. If by not starting you
mean it will not turn engine, but if the engine is turning then the
starter is turning so it is something else all together. Starters will usually work when they are cold then once warm or hot they will not work. Hope this helps!