Question about 1987 Isuzu Trooper

1 Answer

Clutch on 91 trooper

New clutch was installed now hard to shift into gear and vehicle moves when pedal is to the floor

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,669 Answers

Hydraulic clutch= Bleed the System
Cable clutch= adjust the cable

Posted on Feb 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

91 jeep wrangler YJ shifting problems


do you mean it wont go into gear ? if so what gears ? it could be the clutch going out , if the pedal is soft or easy to push down than it probably needs a clutch. next time it wont go into gear try pumping the clutch or putting it from 2nd to 1st or what ever gear it has problems with

Dec 18, 2013 | Cars & Trucks

1 Answer

86 acura legend manual transmission shifting problems


so the problem is that you cannot get it into gear from a stop
(grinds trying to force into gear) . if you have a clutch pedal, what I mean is that clutch pedal has pressure behind it,moves up and down by itself, then its a clutch assy needs replaced.clutch disc/pressure plate/release bearing. if there is no pedal,falls to floor, its either clutch slave or clutch master failure issue(lost all fluid). but nothing points at needing a transmission,it should be fine

Apr 04, 2013 | 1986 Acura Legend

2 Answers

Isuzu trooper gearbox problems


You need to be a bit more specific when describing your problem. By "not getting any gears" do you mean (A) the shift lever will not move into position to select a gear?, or (B) shifts into gear position, but does not move? For (A), try reverse (it is not synchronized); Do you get a grinding of gears sound when you try to engage it? If so, this sounds like a problem with the hydraulic clutch release system. If it gets low on fluid, it will not release enough to let you put it in gear. top off the reservoir(tiny 1/2 cup sized one on driver side fender under hood below and to the right of the brake master cylinder) and frantically pump the clutch pedal about 100 times (that\'s right, 100!)
If the tranny goes into gear but the vehicle won\'t move, this sounds like either the clutch disc is worn too thin to grab, or something is broken in the driveline. Try locking the hubs and putting it into 4WD and see if it moves then. If so, then the rear wheel driveline or driveshaft has a problem. Good luck!
<Splinter, LA, CA 1990 Trooper >352,000 miles>

Jan 22, 2013 | 1999 Isuzu Trooper

2 Answers

Shifter works when car is off, start car and then shifter won't go in gear. if i start vehicle in first with clutch pedal to floor, car starts going forward. mazda miata mx-5 just put new slave cylinder in...


The one item I would suspect is the through-out-bearing not completely disengaging the pressure plate from the fly wheel. If the vehicle is in neutral and you slowly depress the clutch and release it do hear a singing or whining sound? Since you cannot adjust the clutch any more the through-out-bearing is the component which moves the pressure plate from the fly wheel to stop the power from the engine to the transmission. It is difficult to shift when the engine is on because the fly wheel is still engaged and powering your transmission.

Aug 06, 2010 | 1997 Mazda MX-5 Miata

2 Answers

I have a 2001 Ford Mustang, v6 3.8 5 speed manual


The clutch is not fully releasing. You can try putting it into some other gear first, then rapidly moving to first gear, but really, you need to either adjust the clutch, or get it repaired.

Jul 07, 2010 | 2001 Ford Mustang

2 Answers

Clutch pedel stuck on floor


The clutch master has blown out

Jan 19, 2010 | 1990 Ford F250

1 Answer

Replaced clutch in 91 Trooper. Will shift through


Sounds like you put the clutch disk on backwards. Your not getting enough throw or you installed the wrong kit.

Aug 19, 2009 | 1991 Isuzu Trooper

2 Answers

Stuck in 5th gear


try bleeding your clutch

Aug 19, 2008 | 1991 Ford Ranger Supercab

Not finding what you are looking for?
Cars & Trucks Logo

351 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...