Question about 2001 Dodge Dakota

1 Answer

Broken rear slideing glass window on a dodge dakota 2001.

I reciently had my sliding rear window broken in a dodge dakota 2001 and ordered a replacement. how do i remove the old window ?

Posted by on

  • Anonymous Apr 01, 2014

    I am looking for the best deal on an OE replacement rear transmission mount(s) for a 2004 dodge dakota sxt rwd v6 3.7L, what and where to order parts?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 59 Answers

On this truck the rear window is glued in with urethane, if I was cutting it out I would use a special power tool designed to do this. I am sorry but this will not be easy with out it, the only thing I could see is you bending and cut the frame off with a scraper and hammer. (bad picture in my mind) might be worth a stop at an auto glass shop and ask them to remove.

Posted on Feb 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need a price on the back window for my Dodge Dakota Truck and yes it is a slider


E-Bay

Window Slider RR - YouTube

? 3:21
www.youtube.com/watch?v=TR1-beP3ebE
Sep 22, 2009 - Uploaded by filbert383
HOW TO: Remove and replace the slider glass in a Gen IIIDodge Dakota. ... Very good, I have a 1991 Dodge Dakota and the rear window leake. So last .... Pickup trucks sliding rearwindow Back glass movable replacement ..

Sep 19, 2015 | Dodge Cars & Trucks

1 Answer

How do I install new quarter glass on a Dodge Dakota? I got the glass plus trim from a salvage yard, but can't see how to access the bolts on the inside of the truck. Looks like I need to remove interior...


Yes, my 2003 dodge durango required a phillips screw driver, and a large (#45 or 50?) torx for the seatbelt connection. other than that I was able to remove the snap in panels and head liner with my hands. some of them unsnap at the top, and then slide them up to disengage the tabs. just use good judgment. the glass is held in with ten, 10mm nuts. the glass will be stuck with butyl caulk, but careful use of a putty knife should get it loose. be very careful not to cut your hands on broken glass ! use gloves ! clean the old butyl from the pinch weld with a plastic putty knife.

Oct 17, 2009 | 2000 Dodge Dakota Quad Cab

2 Answers

How do you remove the rear glass on a 1997 dodge dakota. I am in need of replacing my broken glass.


You can start by pulling the interior back by the rear window. There are two tabs on both ends on the bottom frame, you can bend them straight.Try to pull the bottom of the window out and watch out for the hinges to carefully lift up the window itself.

Sep 24, 2009 | 1997 Dodge Dakota

2 Answers

Broken lug stud on rear of 2001 Dodge Dakota


knock it out and draw in a new one wihtt the lug nut and some spacers.

Sep 23, 2009 | 2001 Dodge Dakota

2 Answers

How do you install a window regulator for a 2001 dodge dakota?


well first take off the door panel it shouldnt be hard remove plastic cover off door.Make sure your window is all the ways up before you remove the motor.you can hold it up with duct tape or anything similar.Then remove the screw that go to the regulator sometimes it has rivets wich have to be drilled off.The new regulator should come with screws if it has rivets if not u use the same old screws.Also unplug the harness of it . Install new one,screw it on and reverse the procedure.Any problems keep me posted

May 23, 2009 | 2001 Dodge Dakota

1 Answer

96 dodge grand caravan drivers side power window---i have broken the nylon slides that attach to the window itself= do i have to replace the whole window monitor or can i buy the two nylon plastic slides...


It sounds like the Regulator is broken and needs to be replaced. Below is a picture of how the glass attaches to the regulator. Note the gold colored clip in the back that holds the glass to the regulator. IF the plastic piece that broke is the WHITE piece in the picture (yours may be black) then it is part of the regulator.
(the black piece in the picture is part of the glass)
480308c.jpg here is a diagram of your door glass / regulator.
b6fdf08.jpg Hope this helps

Apr 16, 2009 | Dodge Grand Caravan Cars & Trucks

1 Answer

2007 dodge dakota


i would stop by an auto glass place or a place that sell only truck parts for help.

Feb 07, 2009 | 2001 Dodge Dakota

1 Answer

Driver side door window slowly fell down into the door of my 1997 dodge dakota. The glass did not break.


Power or crank? Either case the rails that hold the window on probably broke. there are slides inside the door that keep the window in place, if a slide broke, or if one of the brackets broke, the window will come down. I cant really recomend doing this yourself as ive had the same issue on other vehicles and pulling apart the door and messing with the slides and stuff in there is a real pain. Hopefully it only fell off the track and you can put it back in place. If not, if your not very handly i would suggest taking to someone.

Dec 03, 2008 | 1997 Dodge Dakota

1 Answer

Driver side window won't go up


the window regulator needs to be replaced. any parts store should have these as they break all the time

Oct 15, 2008 | 1996 Dodge Dakota

1 Answer

Rear sliding glass window


If u r going to buy a new one, instructions will be included, if u have plans to purchase a used one from a salvage yard, they aren't too difficult to install, the worst part is removing the old glass, and that's already done! Rubber glass seal around outside should be in place, put a rope inside the seal (where the glass will go) leaving a couple of feet or more hanging out at the end. Put the glass in between seal edges as much as you can w/out forcing. W/ a helper, slowly pull the rope out as u push the glass into the seal, the rope pulls back the seal so the glass can slide into the channel. If u have any trouble, don't insert the rope all the way around, this way more of the glass will fit in the rubber channel (seal). Good luck, let me know how it works for u. countrycurt0

Oct 09, 2008 | 2000 Dodge Dakota Quad Cab

Not finding what you are looking for?
2001 Dodge Dakota Logo

Related Topics:

741 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...