Question about 1989 Ford Bronco

1 Answer

Fuel problem my full size 1986 bronco took a hard hit causing it to bottom out. when it bottomed out it turned off. laer we found that the fuel pumps were not comming on when you turned the key on. so we traced the wires and they went into the truck then into a small black box so we finally just ran a wire from the battrey to the wire we traced and the both pumps come on but the bronco still would not start do you have any ideas

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 114 Answers

Hi there.... in the passenger compartment you will find and inertia switch. It is usually located behind the kick panel on the pasenger side. Pull the kick panel of and you should find a box with a button (usually red) push the button in and you fuel pumps should work again.

Posted on Feb 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Full size 1986 ford bronco cranks but won't turn over


Is the air filter and fuel filter clean. How long since your last tune up?

Mar 02, 2014 | 1986 Ford Bronco

1 Answer

Where is the fuel pump on a 1986 ford bronco II v-6 fuel injected engine


the pump is on the top of the fuel tank and goes down inside the tank from there.

you have to drop the tank to get to the fuel pump.

Jan 11, 2010 | 1986 Ford Bronco II

1 Answer

Fuel pump will not trun on


sometimes when u hit the bottom of the gas tank the feul pump will turn on. if this is the case then u have to replace the feul sending unit.

Nov 17, 2009 | 1994 Ford Bronco

1 Answer

'86 F150 fuel pump shut off switch won't reset


check the wiring connector at the bottom of the cutoff switch is it burnt? use a 12 volt test light (avil at any parts store for around $6) to see if it lights up in and out of switch while cranking.

Jul 01, 2009 | 1986 Ford F150 SuperCab

1 Answer

1990 bronco full size 160000 miles. When I depress the clutch and turn the key all the warning lights go on, but won't start. No noise. Often it will start after a couple more tries, sometimes have to...


check to see if the fuel pump in the tank is running if not trust me on this one take your hand and hit the bottom of the fuel tank it will jar the brushes in the motor of the fuel pump and it will start right up .If this don't work for you you may have a bad fuel pump relay however it really sound like the pump to me .Hope this helps you!!

Jun 05, 2009 | 1990 Ford Bronco

1 Answer

Fuel pump switch


also known as the inertia switch is located on the left kick panel area by the emergency brake pedal . 90 full size bronko .

J5

Jan 16, 2009 | 1990 Ford Bronco

1 Answer

No spark and no fuel


try eec control relay. located on the driver side fender along with the fuel pump relay. sometimes those relays short out

Oct 18, 2008 | 1987 Ford Bronco

2 Answers

2001 ford windstar van (fuel pump)


changing fuel pump on my 2001 ford windstar van....trying to replace pump only not whole housing like i'm used to...i'll post results

Sep 22, 2008 | 1988 Ford Bronco II

2 Answers

Bronco Wont Start (help please)


Check for timing gear problems. They have plastic teeth on the cam shaft gear which will shatter causing it to jump time.

Aug 03, 2008 | 1981 Ford Bronco

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

152 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...