Question about 1997 Mercury Mountaineer

1 Answer

2000 mercury mountaineer no manual

Tail lights and dash lights not working, no maual, just need to know which fuses to check, including the main fuse box under the hood or just a step by step trouble shooting guide

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mercury Master
  • 4,369 Answers

Here;s a diagram

2000 mercury mountaineer no manual - 91adafa.gif

Posted on Mar 04, 2009

  • gerry bissi Mar 04, 2009

    fuse 3 - 15 amps in car

    fuse 26 - 10 amp in car





    fuse 11 - 15 amp in engine compartment fuse box

×

4 Suggested Answers

dcramer531
  • 1654 Answers

SOURCE: What fuse # will fix my dash lights and tail

a 15 amp blue fuse located in the engine compartment fuse box location 17.These are all connected to the same circuit.

check out www . motorcraft service . com ( no spaces )

click on Owner Guides

The owners manual ( includes fuse box diagram ) can be viewed on-line



Posted on Mar 31, 2011

fingaz22
  • 1068 Answers

SOURCE: my hood wont close on a 98 mercury mountaineer

if it doesn't lock then i would look at the latch assembly and spray it with wd-40 they get stuck because of rust and corrosion. also take a look at the handle inside the vehicle they also get stuck in the pulled out position and causing the hood to not lock. give it a push to insure it is in the full depressed position. good luck

Posted on Sep 22, 2009

  • 478 Answers

SOURCE: hood release does not work on my 97 mercury

if you can get to the bolts that hold the lock in place from the front and bottom you can open the hood and replace the bad cable then remount the locking bracket

Posted on Feb 11, 2010

  • 2 Answers

SOURCE: Mercury mountaineer check engine light help

My 2002 M Mountaineer had the same problem and was fixed by reading the code that showed a leak in the gas tank pressure via the cap. When I replaced this with a good after market cap and drove the car for a while and it cleared itself. A mechanic told me that's not possible, but it did clear and has not lit up except on start up where it lights for a few seconds to test the bulb - a normal function.

Posted on Jul 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tail lights not working


All of the marker and tail lights are powered from a 15amp fuse going thru the headlight switch on a brown wire. Do you have power from that circuit coming out of the headlight switch ?

Jan 25, 2014 | Mercury Cars & Trucks

1 Answer

Dash lights and tail lights don't work


Lights and electrical circuits are sometimes in pairs so that you notice something is wrong (tail lights and dash). On a '90 merc grand marq., that would be fuse #4,the 15 amp blue one, in the panel next to your left foot. If you are lucky,it
just failed from age. If you are not lucky, there is a short in the system containing
the dash, tail,parking,side marker, license lamps and trailer tow relay if equiped.I had to replace the push/pull main light switch which was shorted. If you are lucky, just replacing the fuse in the panel will do it. Referance Grand Marquis Owners Manual for fuses and function.

Apr 12, 2012 | 1990 Mercury Grand Marquis

1 Answer

Fuse location


check the manual!

Apr 07, 2012 | Cars & Trucks

2 Answers

No tail lights or inside lights or radio????


Often times the tail lights and dash lights are powered by the same fuse. The reason for this was so you would know that your tail lights weren't working if you didn't have any dash lights. I would look for a fuse that says "Tail" or "Courtesy". Your owners manual should have an illustration of the fuse panel and what circuits they power. Good luck, hope this helps!

Mar 10, 2011 | Mercury Sable Cars & Trucks

2 Answers

No tail lights early morning or evening


The circuit board witch holds the tail light bulbs could be at fault,check the voltage to the tail lights when this happens,if there is none,replace the headlight switch.If there is voltage to the tail lights,replace the tail light assembelys

Jul 10, 2010 | 2000 Pontiac Montana

3 Answers

Dash lights and tail light not working


The dash lights and tailights are on the same fuse link. everything else will work like brake lights and turn signals but this one fuse causues alot of problems. Sometimes this fuses isnt marked on your cover so you might have to look in the maual to find the right fuse . some will be under the hood some will be under the dash .

Good luck to you all on finding this little fuse hope you find it before the cops pulls out behind you when its dark :)

Jul 04, 2008 | 1993 Ford Crown Victoria

Not finding what you are looking for?
1997 Mercury Mountaineer Logo

Related Topics:

1,187 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...