Question about Hyundai Motor 1991 Scoupe

2 Answers

Need timing setting before T.D.C for 1991 hyundai scoupe 1500cc

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

I have a 92, its 10 degress BTDC

Posted on Oct 20, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Hyundai Master
  • 6,674 Answers

Posted on Feb 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1994 hyundai scoupe and it is not getting any power with a new battery


Will it start and if so do you need to boost it every time you need to define no power

Jan 08, 2013 | Hyundai Motor 1994 Scoupe

1 Answer

1991 hyundai scoupe; engine cranks but does not start, check engine light came on then off about three times before this occurred. Car has fuel, checked injectors, fuel pump, plugs, rotar. think it might...


You stated the 'CHECK ENGINE' light came 'ON'!... what/which DTC'S (Diagnostic Trouble Codes) OBDI were retrieved? In 1991, OBDI (1) was used. You could retrieve codes by either turning the ignition switch on/off two or three time within 3 seconds and the light would flash for each number (this way you could determine which system was affected). The POSSIBLE CAUSES are many:

Crank Position Sensor
Ignition Coils/Wires
Water/contaminated fuel
Electrical (Relay(s), fuse(s), Poor ground connections, failed ECU (Engine Control Unit), etc.

Are you getting a SPARK to the plugs?... if so, check fuel pump pressure
If you're not getting a spark to the plugs or not getting a fuel injector PULSE, then the crank position sensor MIGHT BE the problem.... NOT SURE!

Too many POSSIBLE or PROBABLE causes.

In order for an engine to RUN, it needs these things:

1. Air flow (intake AND exhaust)
2. Fuel (proper fuel to air mixture)
3. Compression (140 to 2?? psi)
4. Proper Timing (not too advanced/retarded)
5. Ignition (sufficient and at the correct/right time)

Now, after listing these 5 things, without CHECKING each one, your guess is a good as mine.

Mar 22, 2011 | Hyundai Motor 1991 Scoupe

1 Answer

I have put numerous parts on a 1995 coupe 1500cc


does this car have a delay or warmup loop will not shift till the temp reaches the 192 of the thermestat. kia 's do and some of the hyundai's
if all is fine check the mass airflow sensor unless it has a carb
make sure the throtle plates in the tbi are working

Feb 24, 2010 | 1995 Hyundai Scoupe

2 Answers

How do i fix a hyundai scoupe starting problem? someimes when i go to start my car i have to turn it over several times before i get anything. and then other times it will start just fine. we replaced the...


If you have a national auto parts chain store near you (autozone, advanced auto parts, pep boys,etc etc) Have them hook up an obd2 tester to your car and see if any codes come up(they do this for free!!!). If nothing then I would check the ignition switch module inside the steering column, it may be energizing the starter motor but not sending a signal to the ecu that the car is trying to be started.

Jan 20, 2010 | Hyundai Motor 1991 Scoupe

1 Answer

I want fuse box guide of hyundai scoupe in


Try http://www.helminc.com. They may have this available in Print on Demand.

Dec 24, 2009 | Hyundai Motor 1994 Scoupe

1 Answer

Can't find where the fuel filter is.


sorry i don't have books that far back but a 1993 scoupe had the filter located next to the windshield wiper motor. held on by a strap and 1 bolt there is a gas line on the top and bottom of the filter,with a banjo fitting on the ends.hopes this helps.let me know.

Oct 31, 2009 | Hyundai Motor 1991 Scoupe

1 Answer

Can you tell me where the thermostatic control is in the engine on a scoupe 1991 hyundai


Follw the top radiator hose to were it ends, there will be a hosing with two bolts, undo bolts, lift of housing to reveal thermostat, use new gasket when relacing

Mar 29, 2009 | Hyundai Motor 1991 Scoupe

1 Answer

Oil for Hyundai Scoupe 95


I would say it would be 5w30 but the oil cap would say

Mar 23, 2009 | 1995 Hyundai Scoupe

1 Answer

1991 hyundai scoupe codes


hi
code 21 (ECT) ENGINE COOLANT TEMPERATURE SENSOR
harness and connector OR (ECT) sensor
code 24 (VSS) VEHICLE SPEED SENSOR ]
harness and connector OR (VSS) sensor

WITH MY BEST WISHES

Jul 01, 2008 | Hyundai Motor 1991 Scoupe

Not finding what you are looking for?
Hyundai Motor 1991 Scoupe Logo

Related Topics:

151 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...