- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
It could be located inside the distributor, or mounted on bracket in the engine compartment or in the power train computer. What are your car symptoms? if it turns on, but as you're driving it turns off and it happens frequently; it could be the crankshaft position sensor. This was only suggestion that you might want to check out. I only paid $12.00 at auto zone for my crankshaft position sensor. Good luck and take care. :-)
this is usually caused by a problem with the exhaust camshaft actuator. this engine uses variable camshaft timing. there is a gear mounted on the exhaust camshaft that rotates that changes valve timing. this can can be caused by a bad gear actuator or a bad solenoid. there is a sol mounted on the right front corner of cylinder head. you can start by replacing this part and see what happens
From the information I could gather, you will have to have a dealer reset the sensor. You might call Auto Zone auto parts store and see if they can do it, since they will scan your computer for free. Their scanner may have the capability to reset the sensor.
Generic P-CodeDRB Scan Tool DisplayBrief Description of DTC
1/1 Fuel System Lean
A lean air/fuel mixture has been indicated by an abnormally rich correction factor.
No Crank Reference Signal at PCM
No reference signal (crankshaft position sensor) detected during engine cranking.
No RPM Signal to PCM (Crankshaft Position Sensor Signal to JTEC)
A CKP signal has not been detected at th For more details, you can visit the obd_dtc_jeep
the camshaft position sensor goes inside the distributor. the crankshaft position sensor is located at the rear of the engine, drivers side oem part #56027865AB for automatic trans. part #56027871 for manual transmision