Question about 2002 Ford F150 Regular Cab

1 Answer

07 ford f150 bent axel

I have a 07 ford f150 and the axel is bent how do i remove it?

Posted by on

  • Anonymous Mar 15, 2014

    can a bent frame on a ford f150 be fixed?
    It's bent beneath the front driver side

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 73 Answers

The easyiest way is to use a slide hammer but a crow bar will do the trick as well.but you first must remove it from the spindle.step 1 remove the axle nut in the spindle.step2 remove the upper strut rod retaining bolts to allow you to pivot the spindle{this may also require you to remove the tie rods and swaybar end links.Step 3 pry between the axle and transmission.there will be a lot of force because there is a retaing ring inside the transmission.istalation is reverse of removal.any more info needed please feel free to email me at poppinwheelies@sbcglobal.net good luck

Posted on Feb 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rear axel seal replacement 1988 Ford F150


Pull rear differential cover, remove small bolt/pin that holds pin in, remove pin, push axles in and remove both c clips, pull axles out and then remove seals....reverse procedure but ensure to fill diff with gear oil until it comes out the fill hole.

Feb 17, 2015 | Ford Cars & Trucks

2 Answers

1992 ford f150 speedometer quit working and ABS light is on, also odometer is not working


where the speedometer cable goes into the transmission under the car, when removed from the trans there is a small gear that gets worn out over time.. that little gear or the entire speedometer cable needs to be replaced. An easy and inexpensive fix. I believe the ABS light is on because the computer needs the speed of the car to make its calculations for braking. As long as the speedometer is not working, it cannot do that. So after the speedometer cable issue is fixed, that issue should be fixed as well.

Mar 25, 2011 | 1992 Ford F150 SuperCab

1 Answer

Rear axel fill plug? 2001 ford super crew


Located on the rear of the axle in the middle of pan cover. This is only plug to fill rear ahle. It helps to remove fluid with the suction pump before removing bolts to drain rest of the fluid.

Feb 21, 2010 | 2001 Ford F150 Styleside SuperCrew

1 Answer

I dont know how to remove the passenger side front axel in my 1986 ford f150


pull off the rotor-caliper-and behind the rotor is the hub,unbolt it and use a chisel to separate it from the housing,pull that off and wiggle the axel shaft lightly while pulling out and it barely fits through but it will come out.there is a rubber boot on the inner part of the axel,so cut off the clamp so it will come apart..dont hit the threads on the hub,ive done that once and had to use a triangler file to fix the threads

Dec 25, 2009 | 1986 Ford F150 SuperCab

1 Answer

How to remove 1995 f150 manual locking hubs


after pulling off the outside cover(6 bolts)there is a large ring that has to come out on the inside of the hub,i used 2 small flat screwdrivers to remove it,then 1 snap ring on the end of the axel shaft,then put 2 screws back in the end of the hub and pull on the screws and wiggle and it should come out.

Nov 11, 2009 | 1995 Ford F150 Styleside Regular Cab

1 Answer

Do I need to remove axel?


rearend bearings are pressed in mechanicly so they are very tighly pressed in it all depends where the bearing is located if it is a wheel bearing the answer is no but you might need special tools

May 31, 2009 | 1997 Ford F150 Regular Cab

1 Answer

Rear axle seal replacement


Drain axel of Fluid, Roemve Diff Cover (Push IN on Axel to reseal at Wheel side) Remove KEEPERS From Insied END of axel then Pull OUT on WHEEL END of Axel. use Proper Seal removal tool to remove seal. Also Use PROPER Install tool for SEAL INSTALL Reverse Procedure to Install. In hopes this helps you Out.
Please RATE Me Also LoL Thank You.

Mar 24, 2009 | 1999 Ford F150 Regular Cab

1 Answer

Rear wheel axel Ford F150 2002 how do I dismantel it to check if it is a bearing, making a clunk sond , parked as it has gotten, worse. I have very little money and I would like to fix it myself.


check for a propshaft UJ worn first vehicle up in air wheel free then grasp front and rear of each joint in turn and give it twist ,iam pretty sure this has gone and not the pinnion/crownwheel.

Nov 18, 2008 | 2002 Ford F150 Regular Cab

1 Answer

1998 ford f150 tow weight?


your gvw should be in drivers door plate it varys on how many axels are on trailer its not pulling power you worry about its stopping power

Aug 01, 2008 | 1998 Ford F150 Regular Cab

Not finding what you are looking for?
2002 Ford F150 Regular Cab Logo

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...