Question about 2000 Mercury Villager

1 Answer

Cant find air temp sensor

I just cant find it the sence

Posted by on

  • gerry bissi May 11, 2010

    air temp for air going into engine or you temp reading in car on IP?

  • yadayada
    yadayada May 11, 2010

    if u are talking about the IAT sensor it is either in the air hose to the engine from the air cleaner or in the top of the air cleaner cleaner housing, is it the Intake air temp sensor u are referring to?



1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

If u r referring to climate sensor my van solution was under right side of dashboard by the blowerfan is was burn i pay about 55 dollars

Posted on Apr 09, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2006 Barina manual. Driving, suddenly clutch doesn't engage on take off. Waited and then it grated and worked. Temp of car suddenly rises, air con then blows hot air. Stop, engine super hot

The only scenario that i can think of that could create all of your issues is your clutch is and has been slipping for some time. All other train of thoughts really don't make sence. This would give issue either selecting a gear whilst driving or possible slecting gear and engine speed raising but vehicle not moving from a stand still start on sharp pull away. Engine speed would be running higher than required most of the time which would increase engine temp considerably. Due to extreem engine temp your air con would probably switch off as to not put additional load on your engine creating even higher tempratures. My advise is It really needs a visual / test drive to confirm a diagnosis by a qualified person for this information to be confirmed. I hope this makes sence good luck.

Jan 12, 2017 | 2006 Holden Barina

1 Answer

Cant get code p0110 to go away have replaced iat sensor on 97 nissan 200sx what do i do next

its a air inlet temp sensor code if that sensor is good check the coolant temp sensor and trans temp sensors if there not close in temp it trips the code

Sep 23, 2012 | 1997 Nissan 200SX

1 Answer

Were is the intake air temp sensor located on a 2001 chrysler 300m

P0112 is the code for a intake air sensor problem. If you can buy one seperate it will be located between the Air filter and the Throttle Body ... usally near the Mass Air flow sensor . I am a Jaguar Tech our are located inside the Mass Air sensor . Also ck the actuall housing of the air filter assembly

Aug 05, 2012 | 2001 Chrysler 300M

1 Answer

Where is the ambient air temp sensor for the 03 crown vic p71

i have a 99 crown vic suvillan and i cant find the ambient air temp sensor where is it please help

Mar 02, 2011 | 2003 Ford Crown Victoria

2 Answers

I cant find ant information on how to find/locate my IAT sensor in a 96' Ford Explorer 4x4 4.0.. I want to try to fix it myself & cant find any information so any help I can get @ all would be greatly...

the intake air temp sensor is in the air snorkel in between the throttle body and the air box. There will be a two wire connector connected to it.

Dec 10, 2010 | Ford Explorer Cars & Trucks

3 Answers

I have a code on my 2004 KIA that reads po113 that says its a intake air temp cicuit ware is that on my car

The Intake Air Temperature sensor sends a reading to the main engine computer as to what temp the incoming air going into the engine is, for maximum engine fuel efficiency. On rio's, they often go bad due to their location in the intake manifold.. They are a bit tricky to get to, so take your time and use a 10mm socket with a 12-16" extension. They are located just to the right of the throttle body in the back area of the engine. Otherwise have a pro fix it.

Jan 25, 2010 | 2004 Kia Rio

1 Answer

I have changed the MAF sensor on the Korando and it is now running too rich as if the auto choke is still opening. I now have an air temp sensor to fit but cant find it in the air box or ducting. Seems...

i just did a little research on these. being that im from the states i havent had a ton of experience with these but some. the maf you replaced is also refered to as a hfm or hot film mass meter. the air temp sensor is inclusive. i hope this helps.

Dec 28, 2009 | Daewoo Korando Cars & Trucks

2 Answers

Where is iat sensor located on 2000 mazda mpv van . i have a p0113 code and cant find sensor

the IAT sensor is part of the Mass Airflow sensor. here is a picture of that sensor.


Dec 16, 2009 | 2000 Mazda MPV

1 Answer

I cant find the ats {air temp sensor } on a 1990 300 zx

There isn't an Air temp sensor on these cars. There is a mass air flow, which is located under the center nose panel between the two headlights.

There is the ambient temp sensor for the ac/heater. Are you talking about this?

Dec 14, 2008 | 1992 Nissan 300ZX

1 Answer

Exact location of iat sensor I cant find it either.

It is in the rubber air intake hose after the MAF sensor, IAT stands for intake air temp. sensor

Sep 21, 2008 | 2006 Pontiac G6

Not finding what you are looking for?
2000 Mercury Villager Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts


Level 3 Expert

77499 Answers


Level 3 Expert

5626 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides