Heat wont work in a 97 dodge intrepid - 1995 Dodge Intrepid

gffgfgfgf

have u tryed to replace the camshaft sensor i had the same problem with my 97 intrepid today and itworks like a dream now.

worn clutch plates, bad valve body, low fluid, input shaft drum scored, & or bad torque convertor

You need to go through the proper coolant system bleeding procedure.. There is a bleeder valve in the front center of the intake manifold. You must fill the system, run the car with the heat on until the thermostat opens, top off the coolant and open the bleeder until coolant a steady stream comes out without any air bubbles. Close bleeder, top off coolant, and replace radiator cap. Run car until fan cycles twice on its own.

I'm guessing this Intrepid is a 3.5 cause I have never had this problem with a 3.3 But what I found what always caused it in a 3.5 is bad intake gaskets allowing more air to flow into the engine. Change both upper and lower intake gaskets and this should fix the problem. However when changing the lower intake gaskets there are two bolts that are probably gonna give you problems. The one closest to the front and the one closest to the back. They are the bolts that hold the intake down and go into the head near the coolant ports. These bolts are probably going to break off. The good news is they most of the time break off and there is still a lot of bolt left once you get the intake off to get a vice grips on. Have a torch with a good heating tip handy and someone that really knows how to use it and heat the cyl head around the bolt and then try to get it out with the vice grips, but be very careful cause heating aluminium can be very tricky too much heat and you ruined the head.

sounds like the resistor, is it climate controlled?

My motor(2.7) in my 99 dodge intrepid keeps going out. Why is that?

check your instrument panel fuse in the fuse box, the instrument cluster is operated by the same circuit

Check down under dash by left side of brake pedal area.

it can only be two other things, make sure the fan is working and if the fan is working, then you need to change the head gasket.