Question about 1988 Mazda B2600 Cab Plus

1 Answer

Car dying out on acceleration

Mazda b2600 1995 twin cab.
car dies out when taking off if as like no fuel, back off and runs sort of ok but press peddle again and it dies then after while picks up and runs ok this doesnt happen all time and car runs ok

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Try having the air flow meter just behind the filter checked i hav a 94 proceed had similar problem and the air flow meter was the cause

Posted on Feb 28, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Wheh i try to start it it sputter and barely start but it chugs and dies i checked fuel line it is getting gas can you help

Check fuel pressure,
most likely you need to replace fuel pump
not that hard and only takes about 30 min
pressure needs to be around 65 lbs
5 lbs less and it wont run

Jul 09, 2014 | 2001 Chevrolet Silverado 1500

1 Answer

Sometimes my jeep sputters like it is running out of gas but it isnt then when i press the gas all the way to the floor it does nothing ,and then it dies if i shut it off and crank it back up it its fine...

The first thing I check for this sort of symptom is the fuel filter. Sometimes you get a bad load of gas with sand or other stuff in it, and it clogs the filter. When you try to accelerate, it either fails to respond or dies. When the engine is off, some of the material seems to fall off and it will run again for a while. It's the cheapest thing to replace, and usually easy to do, so it never hurts to try.

Oct 27, 2009 | 1995 Jeep Grand Cherokee

2 Answers

Car starts then dies

check the air flow meter,and the idle air control valve.check all the sensors for bad connections.

Sep 09, 2009 | 1998 Oldsmobile Cutlass

1 Answer

My Mazda mx3 starts up idles for a couple seconds then dies.

Before you replace the fuel pump, I would check the cheaiper parts first. Such as fuel filter and injectors.

Jun 17, 2009 | 1992 Mazda MX-3

1 Answer

Wants to die out on take off

try pulling the vaccum line from fuel press. regulator, check if there is signs of fuel in hose (shouldnt be).....vaccum test regulator if needed....should hold vac....good luck

Apr 12, 2009 | 1998 Ford F150 Regular Cab

1 Answer

Truck will idle about 15 seconds and dies or bogs down

You need to take a pressure and volume measurement, most fuel pressures for a carburetor engine are 3 to 7 psi, then you need to make sure the volume is consistent for a period of time, 20 to 30 second of engine cranking while the fuel is transferred to a container of some sort, make sure the ignition system is disabled to prevent you from blowing up the property.

Mar 21, 2009 | 1983 Ford F150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

441 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides