Question about 1995 Chevrolet S-10 CA Edition

1 Answer

REPLACE STARTER ON 1995 CHEVY S-10PU 4.3 LTR - 1995 Chevrolet S-10 CA Edition

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 6,784 Answers

Step1 Turn the truck off and disconnect the battery. Lift the car with a jack and place jack stands under the frame of the truck. Block the rear wheels to prevent the truck from rolling backwards. Step2 Locate the starter and remove the wires connected to it. Mark them so you know which is positive and which is negative so you can reconnect them accordingly. Step3 Remove the bolts holding the starter in place. There are usually two or three bolts holding the starter. Step4 Pull the starter out of its position and remove it from the truck. Some other parts may need to be loosened or removed for the starter to be removed from the truck. Remember what parts are removed or loosened. Step5 Put the new starter in the truck by installing it the same way the old starter was removed. Tighten the bolts slightly, connect the wires to the starter and then tighten the bolts completely. Step6 Replace any other parts in the truck that were removed or loosened. Lower the truck from the jack stands, remove the blocks from the rear wheelsREPLACE STARTER ON 1995 CHEVY S-10PU 4.3 LTR - mag-glass_10x10.gif and reconnect the battery. Start the car to make sure everything is working properly.

Posted on Feb 25, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Took all the wires off distributor

1-8-4-3-6-5-7-2 is the firing order for a v8 chevy, look at the cap locate the number one on it, tunk the starter and note rotation, and wire accordingly... chevy is odd numbers on the drivers side 1-3-5-7 and evens on the passenger side 2-4-6-8

Aug 29, 2011 | 1995 GMC Yukon

1 Answer

Audi a6 2 ltr petrol timing marks and torque

ally head 75lbs ,timing marks i honestly cannot remember ,do it old fashioned way time it to no1 with valves closed on no1 then you can see where or what the pmarks should be ,do not use starter motor ,always crank engine by hand 360? to ensure valves clear

Dec 21, 2010 | 1995 Audi A6

1 Answer

I have a 1995 chevy lumina, it will not urn over,

down by the start is a fused link, this link may have burned out and will need replaced before you will get voltage to the starter

Mar 27, 2010 | 1995 Chevrolet Lumina

1 Answer

How hard is it to replace the starter on a 1993

Not that bad, jack up front of car used jack stands, starter sit between radiator and engine, on engine block above oil pan, disconnect battery 1st.

Jan 08, 2010 | 1995 Chevrolet Lumina

1 Answer

Can't get 3rd mounting bolt out of starting motor on 1996 ford thunderbird 4.6 ltr engine it is up next to the engine and you can't see it


Sep 20, 2009 | 1995 Ford Thunderbird

1 Answer

Locate water pump on a 4.5 ltr engine

Follow the large diameter hose from the bottom of the radiator. This hose is connected to the water pump.

Jul 05, 2009 | 1995 Cadillac DeVille

1 Answer

I have water in fuel problem. 6.5 ltr turbo diesel

you can try drygas or seafoam at your local auto parts store.

May 26, 2009 | 1995 Chevrolet C2500

1 Answer

Need to reset computer in 1995 jeep grand cherokee limited editiom 5.2 ltr dont know how. changed starter yesterday ,now jeep wont run any longer than ten secondes, read on this site if i reset computer...

You can try closing all the doors, then locking drivers door using the key...then unlock. Depending upon what system you have, this often works!

Mar 15, 2009 | 1995 Jeep Cherokee

1 Answer

Hard to start when cold

Glow plug relay or the glow plugs are not working the way they should. Also check the cold start solenoid.

Jun 21, 2008 | 1995 Chevrolet Silverado 2500

Not finding what you are looking for?
1995 Chevrolet S-10 CA Edition Logo

174 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides