Question about 2000 Renault 181

1 Answer

CAN ANYONE TELL ME WHERE TO LOCATE THE CRANK SENSOR ON A 2000 RENAULT CLIO

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 298 Answers

It's directly above the flywheel. A new one may require a modified plug soldering-in. Its located on the right side of the engine (if you're standing in front of the car facing it). I suggest you join us on Renault forum. We'd be glad to have you as a new member.

Posted on Jul 27, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Reanult Clio 2002 , the car turn on but dosent start it keeps on cranking until it cuts off as if there is short of sparking fire can anyone help


run the fault codes to determine the area of fault
could be cam/crank position sensors, immobilizer, ignition control module or broken timing belt/chain

Sep 25, 2016 | 2002 Renault Clio

1 Answer

Renault Clio Phase 2 - tailgate. Anyone know if


tail gates are completely assembled before fitting on the assembly line and that includes the wiring harness for the gate . So I would expect a harness connector either in side the gate or in a body panel trim close to the gate.

Oct 12, 2013 | 2000 Renault 181

1 Answer

Renault clio 1.5d timing marks diagram


special tools needed ,one to go through the bolt hole in front of engine block right hand side ,remove bolt and then screw special bolt/locating pin in ,common rail doesnt need timiing in as its only a pump ,cam is located by aligning sensor with lug on cam .This is not a do it yourself job special tools needed to lock the crank into position after removing starter motor as well also crank pulley is on a taper and the cam .better off taking it to a dealer

Oct 14, 2010 | Renault Fuego Cars & Trucks

1 Answer

Where is my temprature seensor on renault clio


Hello this temprature switch is located on the drivers side of cylender head faceing towards strut pot.

Dec 24, 2009 | Renault 181 Cars & Trucks

1 Answer

2000 renault clio 1.9Dti si timing setting on cam belt


hi from the uk i can scan and e mail you the full instructions and diagram ofbelt timing+marks for alignment plus correct tensioner setting if you send me your e mail address ? best wishes from n/west uk

Nov 25, 2009 | 2000 Renault 181

2 Answers

Oil level sensor clio. Fuel filter location?


the oil level sensor is screwed into the engine block on the front of the engine it has a 2pin connector on the end of it.

as for the fuel filter its probably an intank one, the service life of these ones is something like 160,000 miles, to change these u will need to remove the fuel tank sender unit and if you do make sure its practicaly empty of fuel because the plastic fuel tanks can distort

Aug 29, 2009 | 1986 Renault Sport

5 Answers

Clio 1.2 W reg


try my last solution posted, connectors on renault clios renouned for corroded electrical connection car guaranteed to start unless car needs replacement loom these also prone to fail very bad design of wiring connections they did a better job in the 70s

Aug 09, 2009 | 2000 Renault 181

2 Answers

Warning lights on dashboard


Try pressing the D3 button on your gear shift - little button below the main one. D3 allows for quick acceleration, but the light also shows when the car is locked is gear ('limp home mode') due to another problem.

Jan 29, 2009 | 2000 Renault 181

1 Answer

Starting problems


get the crank sensor (TDC sensor) replaced. It is a very common problem on Renaults. Join us on Renault Forums. Cheers

Nov 14, 2008 | 2001 Renault Sportwagon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

280 people viewed this question

Ask a Question

Usually answered in minutes!

Top Renault Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

xxxxxx xxx

Level 3 Expert

4724 Answers

yadayada
yadayada

Level 3 Expert

63242 Answers

Are you a Renault Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...