Question about 1994 Chevrolet K1500

1 Answer

How do I change the head lights in 1994 Silverado?

I can see anyway the get these out and replace them. Do they come out from the front (outside), or from inside (under the hood)?

Posted by on

  • Mike Buckley
    Mike Buckley Mar 11, 2009

    Thank you so much TreKilla!!!!!

    You just made me a little better!




1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

1.remove the bezel retaining screws there should be 2 on the front inside (near grille 1 top 1 Bottom) and then 1 on top under the hood(near the fender side) then 1 more straight below it under the bottom light (4 Scews in total) *** make sure not to turn your adjustment screws

2.pull the sealed baem unit forward and disconnect the plug from behind

and installation is the opposite hope this helps!

Posted on Mar 11, 2009

  • Trevor Tourond Mar 13, 2009

    pull out the front ( i am just assuming you have sealed beam lights and not halogen)



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Are the head lights on all the time 1999 chevy silverado 1500 4x4

On a 99 chevy silverado if equipped with auto headlamps there is a sensor on the dash near the front center of dash a small black bubble. If it is covered it will cause the lights to stay on. The day time running lights are typically seperate from the head lamps

Jul 13, 2014 | 1999 Chevrolet Silverado 1500

1 Answer

Change front turn signal

The side marker light must be removed in order to get at the turn signal light.
There are two screws holding the side marker light which is situated above the turn signal.
Open the hood.
Remove the phillips head screw at the top of the side marker light.
Using a long #2 Phillips screwdriver, remove the screw on the outside of the side marker light. This can be seen by looking between the lower side of the side marker light and the top side of the turn signal.
The side marker can be moved.
The turn signal has one screw on the top of the fixture that must be removed.
Slide out the turn signal fixture. There is a small feature on the lower front corner of the turn signal fixture that you must note to properly reinstall the turn signal.
In order to get to the bulb, rotate the bulb socket 1/4 turn CW or CCW. The bulb socket is loose.
The bulb is simply pressed into the socket.
Not sure of the type, but it can be found at your locale auto parts store.
The bulb is used in several places on the 1994 GC, so get apacket with two, if possible.
Assembly in reverse. Be careful not to overtighten the screws as they are replaced.

Mar 29, 2011 | 1994 Jeep Grand Cherokee

1 Answer

Rough idle when warm up

check intake gasket for leak. spray carb/choke cleaner all around intake mating surface to cylinder heads, ( while engine running) if rpm changes hi or lo you have a leak and need replaced.

Feb 10, 2011 | 1994 Chevrolet Silverado 2500

3 Answers

1999 chevy silverado

I belive there are 4 torx head screws that you can get to from the front side of the grill.My 1997 did anyways. Hope this helps.

Feb 23, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

Can not figure out how to change bulb in a 1994 chevy silverado

I hope you were asking about the head lamp.Depending what style you have .If you look at the front and see four screws and the headlamps have a chrome bezel around it then you will have to take the whole light out the front.If both head lamps are one piece then the bulbs gets removed from the back.Squeeze and turn then remove the wireing harness.

Jan 20, 2010 | 1994 Chevrolet K1500

2 Answers

1994 CHevy cavalier check engine light comes on


Feb 13, 2009 | 1994 Chevrolet Cavalier

1 Answer

2000 Nissan Frontier replace headlight

there is a holder for the head lights you have to unscrew this holder from the outside on the front of the truck unhook the plug on rear of head light then reverse the process to reinstal good luck

Jan 06, 2009 | 1994 Nissan Pickup

1 Answer

Stereo light bulb replacement.

deep inside head unit at front is the led to replace .. likely soldered into a board there as a non replaceable part ..remove head unit ..disassemble to get behind front panel...good luck..maybe this is not a worthwhile project money/ time wise.... my 2 cents

Oct 27, 2008 | 2000 Chevrolet Silverado

1 Answer

Tail lights replacement

open the tailgate there should be 2 screws at the edge then the tail light will pop out then there are 2 hex head screws that hold the printed circut board to the lense, remove this and the bulbs are on the board.

Jun 18, 2008 | 1994 Chevrolet K1500

Not finding what you are looking for?
Cars & Trucks Logo

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

78238 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides