I am having trouble getting the heads loose because the AC pulley refuses to come off. If I can get them loose, I can get the heads milled and inspected and replaced. I have the gasket and all other parts. I just need the heads off.
Can't you just unbolt the AC system and temporarily move it out of way to to get heads off, C'MON MAN, make it happen !
Testimonial: "I am going to get the heads of today and about that plate. The condenser and Powersteering pump mount to it. Theres two of them that sit on the front of the block."
Ive tried that but theres a plate holding the Heads in
CUT the dam thing off, find another in a bone yard, its not rocket science ,do what you gotta do !, dime holding up DOLLAR !
if you can get to head bolts, take them out, pull the heads . I don.t understand the plate, never heard of it !
if its a bolt holding on this ******** plate, break it off, use a torch, burnit off, chisel & hammer, bust it off !!!!!!!!!!
×
SOURCE: 2004 aveo timing belt broke, all valves bent
just go to any junk yard and find a used deawoo lanos and pull the head if timing belt was not broke, if it looks good, its a exact fit 100%, no special tools needed, just normal wrench set and torqe wrench. after head is installed, get a gates timing belt only.
SOURCE: CHECK ENGINE LIGHT ON , WITH CODE SYSTEM TOO LEAN
Possible failed bank 1 sensor 1 oxygen sensor..
SOURCE: how to replace valve cover gasket 1998 chevy malibu
The first step is to remove all the parts that are in the way of you being able to remove the valve covers. (Ex.: air intake, loose wires etc.) Then you will need to remove your valve covers (using basic tools) and be very careful to not let anything get on your lifters, which your valve covers protect. Once you have the valve covers off compare the new gaskets to make sure they are the right size. Then remove the old gasket and replace with the new one using a high temp gasket sealant (available at any auto parts store) to attach the gasket to the valve covers. Then tighten down snug and check for leaks after replaced.
SOURCE: how do i adjust the valves on a 1999 chevy
push rods are adjusted hydraulically,by oil pressure.your 1 turn further was 1 turn too many.
SOURCE: have leak behind water pump on 94 camaro v6. Looks
that is the distributor behind the waterpump, water pump will come off with \out removing crankshaft pulley, i own a 95 Z28 Lt 1 350, reply to [email protected]
Fig. Fig. 6: Remove the spark plug wire separators from the valve cover
Fig. Fig. 7: Compress the engine air cleaner-to-valve cover hose clamp with pliers, and slide the clamp back ...
Fig. Fig. 8: ... then disconnect the hose from the valve cover
Fig. Fig. 9: Unfasten the valve cover retainers and remove the valve cover-2.0L SOHC engine
If removing more than one valve lifter (tappet), mark the lifters and their locations as they must be installed in their original bores.
To install:
82 views
Usually answered in minutes!
×