Question about 1996 Pontiac Grand Am

1 Answer

Need help with my 1996 grand am gt

I just posted it today it is a stop and stall problem as soon as i hit my brakes i stall but if i take the fuse out for my tallights it does not

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 366 Answers

Something doesnt sound right ,sounds like a bad short but fuse should blow ,did you install or modify something latelyin near that electrical routing,that elec. circuit must be damaged and making contact with one of your primary circuits ignition,fuelpump,inspect brake elec. circuit from brake switch to lights,you should find your problem

Posted on Feb 25, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

96 grand cherokee starts& runs fine but then it goes into pig mode & over fuels dumping black sout out of exhaust


1996 jeep grand cherokee stalling at lights or stop signs - Forums ...

www.cnet.com > Forums > Car Tech

CNETJun 11, 2015 - My jeep grand cherokee 1996 has started stalling when at lights, stop signs, in park or ... It starts and drives but after stoping at the stores and parking when I came out I ... Mechanic changed already crank sensor, distributer pick up, fuel pump, idle .... Symptoms like the Jeep running fine, then stalling without warning usually ... 97 Jeep Grand Cherokee Laredo keep dying upon ignition
Jun 11, 2015
1996 Jeep Grand Cherokee just stopped while driving.
Jun 10, 2015
More results from www.cnet.com
Missing: pig

Nov 23, 2015 | 1996 Jeep Grand Cherokee

1 Answer

2001 grand vitara runs good but stalls every time I hit the brake, I had a corroded positive terminal I replaced it and now I have this problem


stalls, there are 50 ways to stall a motor,
1: engine lost compression. (can do that hot, or over heated)
2: lost spark.
3: bad fueling. (too much or too little)
4: isc sticks (can your right foot avoid the stall easy, bingo ISC.
5: lost electric power to EFI system. lost 12v, (even a loose fuse)

sounds to me #5 based just on the brake deal.

Sep 20, 2013 | 2001 Suzuki Grand Vitara

1 Answer

Jeep Grand Cherokee - 1995 - Intermittent electrical fault. When driving along the power fails for the dashboard completely; the dials and gauges fail, all the lights go out and the radio turns off. It is...


USA CAR>?
power loss 12vdc to cluster.
basic, simple loss can happen. easy
get it fixed?
any shop in town can. that is what 99% do today

if not read the book the sm is free,
takes a $20 DMM meter to find it,
replace the 2 cluster fuses yet, that brake thing is very very odd.
sound to me like engine stall, and total vacuum loss as side effect.
brake hard is not the correct word
brakes hard and work perfectly as manual brakes do
and only the vacuum assists fails
in fact the brakes are totally ok ,just takes more pedal pressure.
BY DESIGN !@!!
its not unsafe unless 85 lb granny drives it.. see?
fuses, are first (always and for SURE 1995)

the book, and click ZJ
then click wiring
Chapter 8w page 40+
this cluster has a VOLT METER
see that?, if it goes to zero (tells you catastrophic power loss)
and head lamps work (DO THEY)???
then the key switch failed.? can be.... but...
or fuse block fuse 21 or 22 below. (or are loose or defective,rusty)
cab box both 15amp ATC fuses.
or fuse 12, under hood. 40amp.




http://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#service

simple no? battery dead, not if Head lamps work)
fuses (all 3) the key switch wiggle it yet?>>>>>?????????
and wires. bad. id bet it not ground G106 bad.

1995-m1auzjphmyem43ddgr3cysau-2-0.jpg

Mar 12, 2017 | 1995 Jeep Grand Cherokee

1 Answer

I have a 2000 grand am gt 3.4l and when i go to stop, as i slow down, the car seems to **** forward and backward slightly as i hit the brakes. would this be my rotors possibly?


Sounds like warped drums or rotors
( shaking when hitting the brakes )
Need to check complete braking system, just in case you have a hanging caliper or wheel cylinder ( if it has drums, that is in back )

May 12, 2010 | 2000 Pontiac Grand Am GT

1 Answer

I have a 1996 Pontiac grand am gt and the fan


make shure relays are good and check temp sensor

Mar 24, 2010 | 1996 Pontiac Grand Am

1 Answer

When I'm holding breaks pedal, the turn signals stops working and engine stalls. Pontiac Grand Am 1998 v6


Sounds like you have a short between your brakes and turn signals. The car needs to be serviced by a dealer.

Dec 09, 2009 | 2000 Pontiac Grand Am GT

2 Answers

ABS, brake, trac control, service engine soon light came.


I'm sorry to say that you will need to see a dealer or repair shop so they scan your ABS for trouble codes first and then find your problem.

Jul 24, 2009 | 2000 Oldsmobile Intrigue

2 Answers

Left brake making loud noise when braking


It's possible the caliper is frozen and has worn one pad down completely. Get it checked, soon

Mar 27, 2009 | 2001 Pontiac Grand Am SE

3 Answers

My 1996 pontaic grandam shakes when i brake


this could be a warped brake disc.. when you brake do you feel the brake peddle go up and down under your foot??? if you do then this is the problem..Hope this helps

Jan 20, 2009 | 1999 Pontiac Grand Am GT

1 Answer

1996 Jeep Grand Cherokee stalls when brakes are applied


My 2000 Grand Cherokee had the same problem, without all the sputtering, it would just die approaching a stop. We could only keep it running by slightly pushing down on the gas petal when coming to a stop. I replaced the Throttle Position Sensor, but that didn't change anything. A new mechanic I found replaced the Idle Air Control Valve, and we've had no problems in a week.

Jan 02, 2009 | 1986 Jeep Cherokee

Not finding what you are looking for?
1996 Pontiac Grand Am Logo

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6876 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...