Question about 2000 Chevrolet Corvette

3 Answers

Service Active Handling, ABS and Traction Control Lights on

I have a 2000 Chevrolet Corvette and the Service Active Handling, ABS and Traction Control lights come on and read in the information bar. No noticiable changes occur while driving. Any thoughts?

Posted by on

  • 1 more comment 
  • gbjnaples May 03, 2009

    2000 corvette ABS and traction lights will not go out, is there away to disconnect the lights so they do not stay lit up on the dashboard all the time, perhaps by disconnecting a fuse??

  • Anonymous Mar 21, 2014

    abs and traction control warning lights stay on

  • Anonymous Mar 24, 2014

    electronic stability control & traction control lights on

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I have had exactly the same problem on and off for 3 years now - and just solved it last week thanks to another computer site. Remove and disassemble both grounds from the top of both the left and right frame rails adjacent to the front corners of the engine block. Completely clean the green corrosion from the internal parts with fine sandpaper and add dielectric grease then re-assemble. Clean the mounting bolt and frame hole while you're at it. Sounds time consuming and difficult, but it ain't. No more than 45 minutes combined. I am a technical airhead so if I can do it so can you. What clued me in was the problem always occurred around wet or humid weather. Also, the clock would always lose time overnite. That has ceased also. Good luck. Anyone know why my left headlite, when deployed, vibrates and shimmys??? Sully ptsully@roadrunner.com

Posted on Jul 07, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 206 Answers

On most cars if the abs and trac lights are on there is a wheel bearing going out. You need to hook up to code rearder to find out which one

Posted on Mar 02, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Traction control won,t stay on, loose power and turn traction control off and all is well till I shut the car off and start again??? note I put 255-50 -17 on front thats when it started. thanks paul

Posted on Sep 02, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why would the information panel in my car display, "Low fuel," "shocks inoperable," "service traction control," "do not exceed 80mpn," "service active handling," ect: and fuel gage reads empty?


G104
Instrument panel harness, below the battery tray, on the RH frame rail, ground for SP208 (CKT 851)
Splice Pack, SP208
Instrument panel harness, RH side of instrument panel, grounded to G104 (CKT 851)
G108
Forward lamp harness, below the battery tray on the frame rail
Fuel Gage
The IPC displays the fuel level as determined by the PCM. The IPC receives a class 2 message from the PCM indicating the fuel level percent. The fuel gage defaults to empty if:
?€¢
The PCM detects a malfunction in the fuel level sensor circuit.


?€¢
The IPC displays a low fuel message on the DIC.


?€¢
The check gages indicator turns on.


SERVICE ACTIVE HNDLG
Refer to ABS Description and Operation in Antilock Brake System
SERVICE TRACTION SYSTEM
Refer to ABS Description and Operation in Antilock Brake System
SHOCKS INOPERATIVE
Refer to Electronic Suspension Control Description and Operation in Electronic Suspension Control
Mite be a good idea to have the vehicle check for DTC'S diagnostic trouble codes if the grounds are good !
This vehicle is equipped with a computer system capable of performing multiple engine and body control functions. Vehicle components such as windows, locks, mirrors, etc. are controlled directly by their system control module. Each system control module communicates with other system control modules on a serial data circuit. The vehicle system control modules are all attached to the serial data circuit that provides the data link communications. This data link, or serial data circuit, provides 2-way communication between various engine and body control system control modules.














I don't

Sep 09, 2015 | 2003 Chevrolet Corvette

1 Answer

2007 corvette abs and traction light restet . How do I reset ?


Think you need an OBD reader to do that as found in GMC workshop, should only cost a few dollars as long as nothing is wrong with the vehicle

Jul 19, 2015 | 2007 Chevrolet Corvette Coupe

2 Answers

I have a 2000 Corvette and the Check Engine light came on, power was decreased and it said check Active Handling System...what does this mean and what kind of problems does it create?


Have the codes checked. There are to many possibilities for your car to list. Repost with the codes. Kind of problems it creates is lost power and handling.

Apr 18, 2015 | 2000 Chevrolet Corvette

1 Answer

1999 Corvette abs lights & active handling goes off after starting car off and on two or three times then styas off


Your ABS module has failed. The ABS module is used as part of the Active Handling system, so it's also possible that the connector has either come disconnected or corroded. Try some WD-40 on the pins.

Apr 09, 2014 | 2000 Chevrolet Corvette

1 Answer

C1296 service active steering


Too major for this forum - you probably should research the code online.
It involves a pressure switch in the EBTCM ( electronic brake control model ) not reading the right voltage signal.
It could be a wiring problem or a faulty sensor which could require having the EBTCM rebuilt.
The active steering - traction control uses the brakes to keep the wheels from spinning or skidding.

Jun 26, 2012 | 2001 Chevrolet Corvette

1 Answer

I have a 99 corvette and I need the ABS, Traction system and Active handling serviced. Warning light for these things are coming on and staying on. What can be the problem? I think it's just the sensor...


I took my 99 vette to the dealer whith the same problem and they replace the rack and pinion because the black wire on top the rack was damaged.

Aug 06, 2011 | 1999 Chevrolet Corvette

1 Answer

On my 2000 corvette the abs and traction lights will not go out is there a way to dissconnet the lights so they not stay lit up all the time on the dashboard


the only true way to fix this problem is to scan it and repair the actual problem if you remove the bulbs the car will not function properly

Nov 22, 2010 | 2000 Chevrolet Corvette

1 Answer

Traction control, active handling, and abs lights are on


these all get there infomation from the abs sensior's at each wheel one of the sensior's could be malfuctiong or the fuse could be bernt out

Jun 04, 2010 | 2001 Chevrolet Corvette

3 Answers

03 Yukon Denali Traction Control/ ABS Problems


my 2000 yukon has the traction control light on and the abs light on any anwsers?

Jul 31, 2009 | 2003 GMC Yukon Denali

1 Answer

Abs trac control light goes on at start up then off


It sounds like an ABS sensor or some other sensor going out. IF it's the main computer for the traction/handling system that's big $$$$$ like $1300+ I think.
This problem frequently starts out as occasional, goes to frequent, and then full time.  It usually relates to the ABS/TC assembly on the frame in front of the engine. 
It is made of two parts, the EBTCM (the electronic part) wich is bolted to the mechanical half, the BPMV (Brake pressure modulating valve.) Sometimes the electronic grounds for this assembly get corroded or loose. Bad connectors for the ABS speed sensors at each wheel hub can also go bad.

EBTCM = Electronic Brake Traction Control Module
Good luck and hope this helps.

Apr 09, 2009 | 2000 Chevrolet Corvette

Not finding what you are looking for?
2000 Chevrolet Corvette Logo

5,062 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...