Question about 1994 Chevrolet C3500

1 Answer

Just did brakes on my 1994 Chevy C3500 2 wheel drive dually. Problem is after I go about 4 to 5 miles I get a vibration in the cab when I brake. It doesn't happen till the brakes are warm. The rotors were turned twice and the pads were replaced twice. I also replaced the bushings on the calipers. Any ideas

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

This can be several different things. First, I would make sure that the rotors were not turned down too much (check the spec's & use a caliper), this could cause them to overheat during braking and create a chaddering effect. I would also make sure that the rear brakes are fully adjusted, so that they are doing their share of braking and not putting the entire load on the front brakes. Then I would flush the brake fluid and check the wheel bearings for wear or lack of grease...

Posted on Feb 24, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 1994 chevey exstended cab 4 wheel drive it has a vibration in front it seems kije uts there when i accelerate then it kinda goes away but then when i brake and slow down it vibrates worst


sounds like you have a warpped brake rotor, bad ball joint, or a bad tire. I would recommed taking the truck to a tire shop and have them shake down the front end that will tell you if its a tire or ball joint

Mar 01, 2011 | 1999 Chevrolet Silverado 1500

2 Answers

I replaced rotors and brakes still vibrates


when does it vibrate, my gosh. vibration when at 65-75mph is balancing, vibration in steering wheel is front brakes. pulsation in brakes is rear. vibration all the time on or off brakes, bad tire............need more info.

Mar 07, 2010 | 2003 Ford F250 Super Duty Crew Cab

2 Answers

I have a 1994 F-350 Crew Cab Dually. Fuse #13 keeps blowing out and the shift lever locks and won't allow me to put the truck in gear to move it. I was told that a swith on the brake pedal could be at...


i would try looking at the wires to the trailer hitch under the rear of the box where the whip that runs to the front which has a plug on it,connects to where it branches off to go to each tail light,somewhere there is a short blowing the brake light fuse.When that happens you wouldnt be able to shift it unless you turn the key on until it unlocks the steering,then shift it to neutral,then start it then it would go into gear to drive it but you still wouldnt have brake lights.

Sep 07, 2009 | 1994 Ford F350 Crew Cab

1 Answer

I need a rear brake diagram for a 89 chevy 3500 4x4


Try this website :-http://www.compnine.com/index I used it to fit a parking brake to our 1999 sierra that had them missing

Aug 04, 2009 | 1994 Chevrolet K2500

1 Answer

Apply brake peddel and brake lights dont come on


its under the dash,just follow the brake pedal up till you see it

Mar 05, 2009 | 1994 Chevrolet Silverado 2500

1 Answer

Brake vibration problem


could be a bad outer tie rod end or lower ball joint on the front suspension, to check jack up wheel (suspension supported) grasp tire and move back and forth, if you feel loosness you have a worn component. if there is no looseness then you have either an bad wheel bearing (excessive runnout) or defective rotors

did you replace All discs front and rear? if not , replace the ones that you previously didnt

Oct 17, 2008 | 1998 Volvo S70

Not finding what you are looking for?
1994 Chevrolet C3500 Logo

258 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

63291 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...