Question about 1992 Nissan Sentra 4 Door

Open Question

How to bleed coolant system on nissan serena mpv

Posted by on

  • ben13window May 22, 2009

    how to bleed coolant system on nissan serena mpv 1997

×

5 Suggested Answers

frcs68
  • 1605 Answers

SOURCE: nissan serena does not start

most likeliy is the ignation module located at the side of the distributor.
chekc the spark from the high voltage plug first, if no spark then you need to replace the IM.




if this answer is helpful, please rate the answer

thank you

Posted on Oct 16, 2008

  • 55 Answers

SOURCE: where does the coolant go in my nissan serena.

The container you are talking about is called the overflow reservoir and yes, that is where you add the coolant. Make sure that your car has been off for a couple hours and is nice and cool before you try to add any, when it's hot it can build pressure and spray coolant or steam out when you unscrew the cap.

Posted on Dec 30, 2008

  • 1 Answer

SOURCE: differance between nissan largo and nissan serena engine

The Engines aren't the same for these two cars.

NISSAN SERENA RUNS EITHER: THE "SR" FAMILY ENGINE or THE "QR" FAMILY ENGINE. Find out which is yours.

NISSAN LARGO RUNS THE "KA" FAMILY ENGINE. IT IS THE SAME ENGINE FOUND INSIDE THE FAMOUS '240SX', I HOPE THIS HELPS YOU.

Posted on Mar 31, 2009

  • 31 Answers

SOURCE: coolant is low. bleeding system?

Hi.You have to open that bleeding screw until all the air is out of the cooling system

Posted on Nov 17, 2009

  • 204 Answers

SOURCE: bleed coolant system

Old methos id to leave the raditor cap off and squeeze the coolant hoses to get the air out.

Posted on Feb 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will an air pocket in the coolant system cause it to overheat or over pressurize on a 2001 Nissan Sentra ?


1. The radiator cap if working correctly it will release pressure in the system provided the cap you have is the correct pressure setting. If you are having a problem with pressure then replace the cap with a new radiator cap with the correct pressure setting. Do not use a cap with a pressure setting other than the original equipment pressure spec. So you do not go to the parts store and buy any radiator cap on the shelf that fits because they come with different pressure ratings and some of these will be totally unsuitable for your car.

2. If the pressure valve is stuck in the "old" cap the pressure release system will not work.

3. Overheating
Air pockets in the cooling system can definitely cause overheating and can retard coolant flow through the system. If you are draining the radiator to replace the coolant or replacing the radiator you need to follow the correct procedures for bleeding air out of the system for that particular engine after coolant refilling. Some engines have bleeder screws on the cooling system to assist in the air bleeding procedure and some don't.

There are various causes for overheating so don't assume it will necessarily be solved by bleeding any remaining air from the cooling system and replacing the radiator cap with one that works.

Other causes can be...........
1. Faulty cooling system thermostat. (Replace the Thermostat)
2. Faulty water pump, especially if the impellers have corroded away or have disintegrated in the case of those design genius water pumps with plastic impellers. (Replace the water pump)

3. Cooling fans not working and if so the cause needs to be tracked. Check that your fans are kicking in. If the engine is overheating the fans should be running because they will switch on when the coolant reaches a specific temp and well before the coolant gets excessively hot.

4. A partial blockage in the coolant passages inside the engine but not in the radiator if you have a new one. If the coolant is not changed at the required intervals(frequently the case with many owners) or is over diluted with water you can get a build up of debris. If products like stop leak have been used in the system this can create similar problems with partial blockages inside the engine coolant passages.

5. A compression leak into the cooling system.
If you have bled air from the system and have continuous air bubbles in the cooling system I would suspect a compression leak. In that event a basic leak down test will show if you have compression gasses leaking into the cooling system and from which cylinder(s). The spark plug is removed and compressed air is forced into the cylinder via the spark plug fitting and air bubbles will show up in the coolant of there is a leak into the cooling system.
--------------------------------
Have the problem with overheating addressed immediately. Running the engine with an overheat condition will cause expensive engine damage many times the cost of fixing the overheating issue.

------------------------------------------------------------------------------

Dec 29, 2015 | Nissan Cars & Trucks

1 Answer

2000 Mazda M.P.V E.S 2.5 bleeding the coolant


I've owned my 2000 MPV since new and in that time and 250K miles later I have replaced the radiator and water pump and overflow tank. I have never bleed the cooling system. I have encountered no cooling related problem. I live in south Florida.

Dec 03, 2014 | 2000 Mazda MPV

1 Answer

Steps to replace water pump mpv 3.0


Remove the battery and battery tray.
Drain the engine coolant.
Remove the water pump drive pulley.
Remove thermostat case
Remove water pump tensioner
Remove water Outlet pipe
Remove water pump
Reverse disassembly order to install water pump.
Fill and bleed cooling system

Aug 14, 2011 | 2004 Mazda MPV

2 Answers

I need a user manual for a Nissan Serena 1.6 van.


You can download the English version from the Nissan Website.

Jul 13, 2010 | 2000 Nissan Sentra

1 Answer

How do you bleed cooling system for 1995 nissan pickup truck


  1. Open radiator cap and air relief plug.
  2. Fill radiator with coolant to specified level.
  3. Close air relief plug.
  4. Run engine and bring to operating temperature.
  5. Race engine two or three times under no-load.
  6. Stop engine and let cool, then add coolant as necessary.

May 10, 2010 | 1995 Nissan Pickup

2 Answers

Nissan Largo 2.0TD 1993, radiator overheating and some loss of coolant. Cooling fans work, but water seems to not get into the top of teh radiator even after opening the caps and the coolant level rising...


I have the same problem but its my interior heaters that wont work my garage says theres two parts to the system poss 3????
take the driver seat out theres a cap to fill there. I kinda thinking Ive got head trouble as my thermastats ok...topping up all the systems does work for a bit on my findings..

Sep 04, 2009 | 1983 Nissan Maxima

1 Answer

My nissan serena will not go lower than 1200 rpm on idle any ideasno nissan dealers close to me if there was they would charge the earth


my nissan serena will not go to change auto gear system. who can solve it please help me to solve the problame.
Thank your verymuch.
Saman.

Apr 15, 2009 | 2000 Nissan Xterra

1 Answer

Where does the coolant go in my nissan serena.


The container you are talking about is called the overflow reservoir and yes, that is where you add the coolant. Make sure that your car has been off for a couple hours and is nice and cool before you try to add any, when it's hot it can build pressure and spray coolant or steam out when you unscrew the cap.

Dec 30, 2008 | 1992 Nissan Sentra 4 Door

1 Answer

Differance between nissan largo and nissan serena engine


The Engines aren't the same for these two cars.

NISSAN SERENA RUNS EITHER: THE "SR" FAMILY ENGINE or THE "QR" FAMILY ENGINE. Find out which is yours.

NISSAN LARGO RUNS THE "KA" FAMILY ENGINE. IT IS THE SAME ENGINE FOUND INSIDE THE FAMOUS '240SX', I HOPE THIS HELPS YOU.

Oct 19, 2008 | 1995 Nissan Sentra

Not finding what you are looking for?
1992 Nissan Sentra 4 Door Logo

Related Topics:

875 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...