Question about 2007 Toyota Yaris

Open Question

Toyota Yaris indicators flash too quick and fail MOT

Toyota Yaris indicators flash too quick (not the same speed as the hazards) and fail MOT, After looking into this it turns out its to do with a little black box fitted in the rear light housing and is something to do with the tow hitch. if i disconnect the box the indicators dont work at all.
HELP

Posted by on

6 Suggested Answers

  • 1861 Answers

SOURCE: tow hitch wiring diagram

Send me your e-mail address, and I will send you a .pdf of the entire rear lighting wiring;
FixYa is not set up to post .pdfs yet.
Glad to help, and thanks for choosing FixYa.

Posted on Nov 03, 2008

  • 2 Answers

SOURCE: warning light on far left next to the temp gage comes on

This is knows as the "bird cage" by most MK3 owners. it's the coolant warning light. It means that either you don't have enough coolant in the system, or that your sensor has gone bad. I recently buoght my 2d MK3 Supra. Both have been 5 spd Turbo. This warning light is a simple fix. If you have any other questions about teh car please visit Supraforums.com They are very knowledgeable about any year Supra there. It's jut a community of Supra owners who will help each other out and give advice on repairing/upgrading. It will really help you learn a lot about your Supra.

Posted on Nov 21, 2008

  • 1043 Answers

SOURCE: 2001 toyota tundra towing issues

There are a number of aftermarket kits specifically made for your vehicle.
I did a quick search on yours, and here's what I found

http://www.etrailer.com/pc-VWH~118378.htm

Not a bad deal for $55, and it's all plug and play.

Posted on Jan 21, 2009

bunnydawg
  • 5158 Answers

SOURCE: toyota yaris freetronic transmission

75w 90

fully synthetic oil would be best in cold climates tho

Robert

Please take a moment to rate this solution thanks

Posted on Jan 27, 2009

  • 184 Answers

SOURCE: Indicator light for a 2003 Toyota Sienna.

Is this it? If so, it means check your tire pressure.
d0149b9.jpg

Posted on Mar 26, 2009

polarcycle
  • 1392 Answers

SOURCE: toyota yaris brakes how do you bleed the brakes on a toyota yaris

have someone pump the pedal and hold it, then you work from the right rear, left rear, right front, left front, while the person pumps and holds several times at each wheel.

Posted on Jun 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is toyota vitz scp 10 p0500 fault


"Vehicle Speed Sensor Malfunction". That may be either related to the speedometer or related to the ABS, if your Yaris is equipped with ABS. It indicates that the car THINKS that it should be able to sense how fast the wheels are turning when you're in motion, but it's getting a strange signal from the sensor.

Since this is a Yaris with front-wheel drive, your speed sensors will be somewhere between the transaxle and the front wheels, probably one on each side. Look for some sort of small device mounted next to the axle shafts or next to the brakes - that device should have wiring connected to it. Check the little electrical connector, make sure it's plugged together correctly. The sensor itself may have failed, though, so be prepared to replace one or the other. if replacing one doesn't solve the problem, put the original one back and use the new one to replace the sensor on the other side of the car.

Jul 30, 2014 | 2001 Toyota Yaris

1 Answer

How do you reset the service indicator light on a 2012 Toyota Yaris


With key in the off position hold trip indicator while turning the key to the ON position. DO NOT START the car and keep holding the trip button. You should see some dashes where your trip usually is. let them go until it flashes zeros. It should be self explanatory after this point.
If this does not work try turning car to ON position then goto trip A then turn car off and do the above again. If this does not work Try starting on trip B like you did with A. It should work on odometer or trip A. honda and toyota are very close to the same like this. I always get them confused. Worst scenario your trip meter is reset to zero

May 26, 2014 | 2012 Toyota Yaris L 2dr Hatchback 1.5L...

1 Answer

Limp mode/ check engine/ slip indicator/


You got the code

Go to the internet (Google)

Type: 2007 Toyota Yaris OBD PO705

Apr 04, 2014 | 2007 Toyota Yaris

1 Answer

Squeaking on Toyota Yaris at slow speed


Service the brake system and check for:
Tyre tread for feather edge.
Worn disc pads.
Warped rotors.
Warped flange.

Jun 12, 2013 | 2007 Toyota Yaris

1 Answer

I went to scan my toyota yaris car and the following codes were give ; temperature ckt low input po117


EOBD II Error Code: P0117
Fault Location:
Engine Coolant Temperature (ECT) Sensor (G62) - Low Input
Possible Cause:
Malfunction Indicator Lamp (MIL) Triggered on first occurrence.
Coolant thermostat.
Wiring short to earth.
Engine coolant temperature (ECT) sensor.

EOBD II Error Code: P0340
Fault Location:
Camshaft Position (CMP) Sensor A (G40), Bank 1 - Circuit Malfunction
Possible Cause:
Malfunction Indicator Lamp (MIL) active.
Wiring from/to Camshaft Position Sensor (CMP) faulty.
Camshaft position (CMP) sensor faulty.
Timing misaligned.
Possible Solutions:
Check Wiring from/to Camshaft Position Sensor.
Check Camshaft Position Sensor.
Check Timing.

EOBD II Error Code: P0500
Fault Location:
Vehicle Speed Sensor (VSS) - Circuit Malfunction
Possible Cause:
Malfunction Indicator Lamp (MIL) Non Emission Fault - No warning light.
Wiring.
Vehicle speed sensor (VSS).
Engine control module (ECM).

Dec 13, 2012 | 2001 Toyota Yaris

1 Answer

Front indicators dont flash


Quick flashing is usually a burnt out bulb.

Oct 27, 2012 | Nissan Cars & Trucks

2 Answers

Malfuntion indicator lamp in my toyota yaris


Most Auto Part stores like napa or kragen will read the malfunction code for you for free. Once you get that done post the code so we can give you a better understanding on your concern. Oh if your light is flashing please don't drive it that means you are doing immediate damage.

Jun 27, 2009 | 2009 Toyota Yaris

1 Answer

Flashing Unit for Indicators Replacement


Most likely it's the hazard switch - the relay for the hazards and the turn signals is built into it. When they start to die, you will see erratic behavior with the turn signals and/or hazards, and eventually they'll both fail completely. Replace your hazard switch on the dash and you'll be good to go.

Aug 31, 2008 | 2000 Audi TT

Not finding what you are looking for?
2007 Toyota Yaris Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...