Question about Mazda 323

Open Question

Remote central locking

I have problem with gemini 6139 remote central locking. it just stop to operate. battery is very good. gemini was built aftermarket by the previus owner.

Posted by on

6 Suggested Answers

  • 208 Answers

SOURCE: remote central locking

I had the same problem with my Focus. There is a fuse on the back of the fuse block under the dash. There are a couple of bolts holding this block in place. Take these bolts out and find the fuse on the back. Mine was blown. Good luck. Also the sensor unit is behind the glove box. With a little prying of the tabs, the glove box will tip down.

Posted on Jul 09, 2008

  • 1 Answer

SOURCE: Central locking not working, Chrysler Voyager Limited 2005

hi this works on most voyagers disconect the possative terminal on the battery for ten minites excactly then reconnect and happy days your voyager centrol locking should work ok good luck

Posted on Feb 10, 2009

  • 83 Answers

SOURCE: 2001 saab 9-5 electric door lock system does not function

Most likely you have a bad TWICE unit. it is located under the driver's seat, at a low point in the floor and often gets wet.

Posted on Mar 25, 2009

  • 1 Answer

SOURCE: yaris 2003 remote control lock problem

You need to reprogram the remote. Please se this website:
http://toyotaownersclub.com/forums/index.php?showtopic=85266

Posted on Oct 12, 2009

  • 17 Answers

SOURCE: peugeot 406 central locking

this may work so give it a try firstly if it was me i would ask the garage who did the work to sort it out as its there fault but failing that put the key in the ignition and hold the lock button for 10-15 seconds this may reprogram it to the car hope it works ;)

Posted on Nov 15, 2009

  • 4793 Answers

SOURCE: changed batteries on my fiat

try this, lock car with key then press and hold lock button (about 15secs)then press unlock button,car should respond....

Posted on Aug 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Central locking 2005 subaru liberty stopped working on 2 doors


1. Replace battery in remote
2. Replace sensor at rhf door lock (it is inside of door)

Apr 30, 2014 | Cars & Trucks

1 Answer

Toyota matrix remote not unlocking car - battery is new


Check to see if your central locking still works on all doors and that you can also operate the driver's door central lock motor.
This can sometimes be an issue with the door lock motors themselves and not necessarily the key.

Nov 18, 2012 | 2005 Toyota Matrix

2 Answers

Central locking not operaiting


Was the car battery disconnected before this central locking problem.Also is the central locking system operated by remote.If yes,then is the remote battery new or old.If the battery in remote is old then try with new battery.Also if the central locking is controlled by a push button in the car then it can be the problem with push button switch .The switch on driver side is got short.It has to be checked with meter to confirm the fault.Apply a direct 12 volt external battery to the switch and check if the central locking is getting done.Also confirm if you can lock the doors manually by using a car key.If you are not able to lock the door with key manually then its faulty door latch.But if the door lock and unlock manually with out any problem then this problem is related to central locking switch or the remote.

Nov 08, 2010 | 2003 Kia Sedona

1 Answer

I have a 1995 VX Landcruiser but only have a key and no remote locking device. The vehicle originally had remotes for the central locking. I've seen aftermarket units advertised that program in to the...


if they say they do,then okay,buy aftermarket remotes, you will need them to reset the alarm if it goes down when you disconnect the battery for any reason.....

Sep 10, 2010 | Toyota Land Cruiser Cars & Trucks

1 Answer

VZ 2005 ute central locking works well from the


is it a factory or aftermarket security system?

Apr 28, 2010 | 2008 GMC Savana Cargo

1 Answer

VW bora 2002 Central locking The remote only


Try disconnecting the cars battery for a few minutes.Remember to have your radio code handy as it will go into safe mode.This should reset your convienience control unit[central locking] and it should operate as normal..good luck

Dec 28, 2009 | 2002 Volkswagen Jetta TDI

1 Answer

My Vauxhall Calibra central locking has locked permanently so that I am not able to get into the vehicle. I have a Cobra demobiliser/ remotely operated lock fitted which responds by flashing and beeping...


What else do you expect from a boy racer sunday mechanic system,rip it out and just use a crook lock ,Nothing but trouble these aftermarket stirling mose or halfords made in china junk .The chips used are poor quality and always go wrong.Also it wouldnt stop me for more than a few minutes to steal car just cut battery earth cable from below the lift car with tow truck.easy

Dec 07, 2009 | 1984 GMC Caballero

1 Answer

Central locking not working, Chrysler Voyager Limited 2005


hi this works on most voyagers disconect the possative terminal on the battery for ten minites excactly then reconnect and happy days your voyager centrol locking should work ok good luck

Jan 03, 2009 | 2004 Chrysler Voyager

1 Answer

Aftermarket installation of remote central locking on 2006 Nissan Navara ST-R


Doesn't matter, I have given up, the existing central locking components are completely different to that of the new kit, I think I will just have to put my tail between my legs and go genuine, getting a Nissan dealership to fit it for me.

Jul 20, 2008 | 2006 Nissan Murano

1 Answer

My battery died after recharging it the alarm buttom needs to be reset. I need to know where the reset buttom is


HI ! I haven' t researched your car for you just yet !

I thought Id quickly mention the common method for reprogramming your alarm & remote, If you still require assistance then just ask me and I will find more about your car :)

Common Methods for resetting/re-learning code

  • Factory Fitted Alarms/ Central Locking / remote comes on ignition key.

Insert ignition key , turn key to accessories / red , press & hold lock/unlock for a few secs.remove key,exit vehicle and try un/lock doors &/or alarm (Some models differ slightly & require engine on or manual use of door locks whilst resetting.

  • Aftermarket /Non-Factory / remote is separately operated
Most use a small back-up battery usually located within the loudspeaker/Alarm unit itself under the bonnet,
Remove this battery for a short period to reset the remote code


The access panel for the backup battery is never in an obvious place. look carefully :)

Jul 14, 2008 | Hyundai Sonata Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

171 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...