Question about 2006 Buick Terraza

1 Answer

Dash light out on left side of fuel guage.

The light on the left side of the fuel guage is out and makes it very hard to see at night. Can this be replaced?

Posted by on

  • Anonymous Apr 07, 2009

    how do i remove the cluster?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 373 Answers

Yes, remove cluster and replace the small light bulb inside

Posted on Feb 24, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Having trouble viewing speedometer gage at night


You can turn your dimmer up, and make sure you are turning on headlights. Newer cars with new guages makes it easy to forget. You can drive on driving lights and still see dash.

Jan 26, 2014 | 2005 Hyundai Tucson GL

1 Answer

My lights for my 2000 yukon xl guages and heater lights wwnt out how do i dix the problem


Either the dash light dimmer is turned off or the dimmer control is defective.

Feb 13, 2012 | 2000 GMC Yukon XL

1 Answer

Where is the check engene light located


Most check engine lights are built in the instrument cluster with your water temp guage,fuel guage oil light or guage and all of the other warning lights.The check engine light will come on when you turn the key on and immediately go out unless there is a problem then the light will flash telling you a problem is detected and then stay on when the problem has to be corrected.Hope that helps and have a good night.

Feb 06, 2011 | 1995 Toyota Camry

1 Answer

2000 mpv . my dash and turn signals stopped working. i have no fuel guage, odometer, rpm, temp guage or turn signal. the turn signals do work if the hazard lights are turned on. the battery also goes dead...


drivers side kick pannel remove it and you will see lots of conectors make sure that they are pluged in i have see this problem befor. or boky controll mod is shot

Nov 28, 2010 | 2000 Mazda MPV

1 Answer

Temp guage stays on cold and engine warning light


You more than likely have a thermostat that is stuck open. When this is the case with the computerized vehicles today the computer tells your engine that it is still cold and dumps more fuel to the engine. When this happens the extra fuel goes through your exhaust and uaually makes the check engine light come on as you have O2 sensors that register this flow. Replace the thermostat, disconnect the negative side of your battery for 5 minutes and re-connect. If this has been going on for a while the light may come back on. You may have to drive it for a while until it clears all the excess fuel out of the system then do the battery thing again. You probably have been getting poor gas mileage as well. Hope this helped. Just make sure that the engine light does not flash as this is a sign of major problems and you should not drive it if it flashes

Feb 06, 2010 | 2005 Ford Mustang

1 Answer

1KZ-TE Toyoto 3L TDi in Granvia Engine Warning Light comes on with hard accelleration when hot and maximum speed steadily lowers to 30mph.Code shows for "low fuel-pressure". Filter changed, pipes all clear...


Install fuel pressure guage, clamp off return side and verify the exact pressure it is producing to the injector rail. Checkmanufacturer specs. If it is not sufficient. Replace pump.

Aug 25, 2009 | Toyota Passenger Cars & Trucks

Not finding what you are looking for?
2006 Buick Terraza Logo

Related Topics:

158 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...