Question about 2003 Chrysler PT Cruiser

1 Answer

Knock Sensor location on a 2004 Dodge ram 1500 5.7 hemi

Where is the location of the knock sensor on a 2004 Dodge ram with a 5.7 Hemi motor? I am getting a code error of P0325.
Thanks
Chris

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Chrysler Master
  • 412 Answers

2 knock sensors are used..small black plastic sensor bolted into engine block below each exhaust manifold..be careful not to over torque bolts upon installation

Posted on May 12, 2009

6 Suggested Answers

  • 2920 Answers

SOURCE: Dodge Ram 1500 can it have a plow?

if you do it do it at the dealer that you got it from so it wont void the warranty. that way you keep it in place and they can also tell you the specifications as to what you need to do ,if anything to the front of the truck

Posted on Jan 26, 2009

chiquititas
  • 1010 Answers

SOURCE: Dodge Ram 1500 can it have a plow?

Yes It can and It should not void the warranty. Contact your dealer.

Posted on May 15, 2008

  • 66 Answers

SOURCE: Need diagram to install serpentine belt on 2004

There should be a diagram under the hood on the fan shroud or radiator support. If not, let me know and I see if I can find one. For the most part, if the pulleys it rides on are grooved, the belt ribs ride on it, it the pulley is smooth, the back side rides on it. From a picture of the alternator I have, from the passenger side coming up, over the alternator, then down and under the belt tensioner (smooth pulley), then up and over A/C compressor, then down and around P/S pump, up and around water pump, down around crankshaft pulley.

Posted on Jun 03, 2009

  • 295 Answers

SOURCE: When is it time to tune-up a 2004 Dodge Ram 1500

30,000 mile plugs but it doesn't meen they need replacement I work for chrysler I would wait till about 50 or 60 thousand remeber just because there is not a problem doesn't meen they should not be replace at the recommened intervals. they are considered a wearable item. when you do the plug do the wires. words of advise when doing the ignition wires do ONE WIRE AT A TIME it will save u from a big headache. Good luck.

Posted on Jul 01, 2009

  • 1796 Answers

SOURCE: I have a 2004 dodge ram 1500 with hemi 5.7. The

Hi!!
The O2 sensor for Bank 1 is located below left front of transmission, in exhaust. Check diag. below.
1kbron_41.gif

Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa.

Posted on Dec 04, 2010

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Code p0325


P0325 OBD-II Trouble Code

Technical Description: Knock Sensor Circuit Malfunction

What does that mean?A knock sensor tells the engine computer when one or more of your engine's cylinders are "knocking", that is, exploding the air/fuel mixture in a way that delivers less power and can be damaging to the engine if prolonged. The computer uses this information to tune the engine so that it doesn't knock. If your knock sensor wasn't operating properly, so that it was always indicating a knock, the engine computer's response may have been to change the ignition timing on your engine. Knock sensors generally bolt into or thread into the engine block. This P0325 code may show up intermittently or the Service Engine light may be lit constantly. Other knock sensor related DTC codes include P0330.

Hope this helps.

Feb 09, 2011 | 2004 Dodge Stratus

2 Answers

I have on 01 xterra-service engine light on-codes P1126 & P0325. I think the battery is about to go,could it be realated to codes? Otherwise what do the codes mean? Appreciate any help


Your battery has nothing to do with these codes. Your vehicles computers have detected a malfunction or failure in the system. This triggers these codes and sets your check engine light. Below I have listed the code meanings and some repair solutions.

P1126 - Throttle Position (Narrow Range) Sensor Circuit Malfunction.

Power supply for the throttle control motor is provided to the ECM via throttle control motor relay. The throttle control motor relay is ON/OFF controlled by the ECM. When the ignition switch is turned ON, the ECM sends an ON signal to throttle control motor relay and battery voltage is provided to the ECM. When the ignition switch is turned OFF, the ECM sends an OFF signal to throttle control motor relay and battery voltage is not provided to the ECM.

Possible Causes For P1126:
- Harness or connectors (Throttle control motor relay circuit is open)
- Throttle control motor relay


P0325 - Knock Sensor Circuit Malfunction

The knock sensor is attached to the cylinder block. It senses engine knocking using a piezoelectric element. A knocking vibration from the cylinder block is sensed as vibrational pressure. This pressure is converted into a voltage signal and sent to the Powertrain Control Module (PCM) or Electronic Control Module (ECM).

Possible Causes For P0325:
- Knock sensor circuit short to ground.
- Knock sensor circuit short to power.
- Knock sensor circuit open.
- Damaged knock sensor.
- Damaged PCM or ECM

Possible Solutions:
- Repair or resecure harness or connector
- Replace knock sensor Bank 1 (Bank 1 if applicable)
- Replace PCM or ECM

The P0325 DTC is a very common problem with Nissan vehicles. On most Nissan vehicles the knock sensor is located on top of the engine block.

knock_sensor_infiniti.gif

Jan 20, 2011 | 2001 Nissan Xterra

1 Answer

Looking for firing and coil order 2004 hemi 5.7


For ALL 2004 Dodge RAM (1500, 2500, and 3500) (2WD and 4WD) 5.7L V8 Hemi:

.........Firing Order:
Coil...1-8-4-3-6-5-7-2
Plug..6-5-7-2-1-8-4-3

This should have been located at the top of the your Intake Manifold.

Let me know if this helped...

Apr 15, 2010 | 1998 Dodge Ram 1500 4WD

3 Answers

05 5.7 hemi burning 1 qt every 700 miles


Rings & bearings & oil pump need urgent attention!
Cheers Rob

Sep 19, 2009 | 2004 Dodge Ram 1500

2 Answers

04 Dodge Ram 1500 Hemi 2WD O2 Seneor


change up and down stream o2 senors

Dec 15, 2008 | 2004 Dodge Ram 1500

1 Answer

Diagnostic code P2299 for 2004 Dodge Ram 1500 5.7 hemi?


P2299-BRAKE PEDAL POSITION / ACCELERATOR PEDAL POSITION INCOMPATIBLE

Set Condition:
The PCM recognizes a brake application following the APPS showing a fixed pedal opening. Temporary or permanent. Internally the PCM will reduce throttle opening below driver demand. One trip fault and the code will be set within 5 seconds. ETC light will illuminate, the light will only stay illuminated while DTC is active.




Possible Causes

DRIVER PRESSING ACCELERATOR PEDAL, THEN PRESSING BRAKE PEDAL, AND CONTINUES TO HOLD THEM DOWN SIMULTANEOUSLY

STOP LAMP SWITCH

APP SENSOR


The most likely cause of this DTC is Brake Torquing the engine by pressing the Accelerator pedal and the pressing the Brake Pedal.

Jul 17, 2008 | 2004 Dodge Ram 1500

Not finding what you are looking for?
2003 Chrysler PT Cruiser Logo

2,484 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

68970 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22026 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...