Question about 1994 Geo Metro

1 Answer

Engine i want to know if you can put a1997 engine in 1994 give and i dill if i can

Posted by on

  • yadayada
    yadayada May 11, 2010




1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Contributor
  • 41 Answers

I think the 97 uses a crank sensor where the 94 doesn't. (not sure) I don't see any reason you can't just leave it unhooked. I put a 92 engine in a 94 but because of the differences in the emission controls, I had to use the 94 intake and injection system. It worked out fine. Still driving it. Some advice, while you have it apart, clean the EGR valve and journals especially the ones going from the exhaust manifold to the EGR valve (driver side of motor). That is a common problem with these cars and it usually ends up ruining the engine. (My experience is with the 3 cyl model).

Posted on Mar 11, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What fact does Dill offer about his father?

One fact, he addmited he was his father...

Dec 17, 2014 | Cars & Trucks

1 Answer

Saab 03 9-3 aero Locked my keys in the boot. Tried pulling the locking mechanism but doesn't work. Is there a way to open the boot or the doors as I know I can get in the boot once in the car

lock smith time,
or dill out lock and buy a newone.
or break a window (tiny) some operators guides say just that.
say deep in the Outback?

Jun 30, 2014 | Cars & Trucks

1 Answer

I want to know how to put a peugeuot 405 1989 model engine on timing

diesel or petrol? what size engine, what do you mean by "putting it on timing"? give as much detail/history as is relevant?

Jan 11, 2013 | Cars & Trucks

1 Answer

"1996 plymouth voyager timing belt" How do I know

get the engine number plus vin number and go to a Chrysler dealership. They can put the info in a computer and give you the correct answer. The SOHC Chrysler 2.4 is a "free-wheeling" engine.

Your drivers handbook should also, (i believe) have that information.

Good luck.

Feb 01, 2011 | 1996 Plymouth Voyager

1 Answer


Your radiator is up front, it has a cap on the top and an expansion tank with a cap on it. Pull the cap off when it is cold, and check the coolant, dill it up in the radiator and fill the expansion tank to the mark on the side. It will level itself out as you drive if you put in too much. You have a condenser in front of the radiator that cools the AC unit. It has no cap, and no access, just don't want to confuse the two.Hope this helps.

Apr 22, 2010 | 1996 Ford Taurus

1 Answer

Fast idle

Sounds like your throttle position sensor is bad.
Take it to Auto Zone and ask them to pull any computer codees that may be latched. Not sll codes trigger the check engine light

Apr 04, 2010 | 1999 Buick Century

1 Answer

Transmission shifting problem

Transmission bands and linkage nees to be adjusted, take to a trans shop.

Jun 30, 2009 | 2002 Kia Spectra

3 Answers

Ignition key is stuck in the ingnition

I had the same problem. The solution is to first remove the key by removing the hole cover on the bottom of the steering column and depressing the plunger. The owner's manual tells you how. If you don't remove the key, the battery will go dead, and you will have trouble opening the rear hatch, where the battery is. You can jump start from the front. It tells you how in the manual. Then take your car to the dealer for replacement of the automatic shifter. The problem is caused by a defect in the shifter made by delphi (I Think). A pin that that goes through the shift rod becomes loose and slides to one side so it does not engage a micro switch that releases the key. GM has know about this problem for some time. I hope you are still under warranty, otherwise it will cost you $475. There is another post on the internet that gives a do-it-yourself fix.

Jan 02, 2009 | 2006 Chevrolet HHR

1 Answer

HYUNDIA Sonata Auto correct timeing

Thank you and all for your concern,PROBLEM SOLVED. I managed to obtain a motor manual (rocket scientist manual more like it).I am from the old school, at my age it looks like Ive got to go back to school again, not on your nelley, sledge hammer will do the trick.For those that love to tinker in the back yard on the old bangers, not any more,whack em on a computer and see where they BURP,then hand over your dolars,yep thems the brakes I made a dill of myself,am not a computer.So back to the motor manual THANKS AGAIN wal-e

Sep 25, 2008 | 1997 Hyundai Sonata

Not finding what you are looking for?
1994 Geo Metro Logo

Related Topics:

159 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Mike Gilbreath

Level 1 Expert

50 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides