Question about 2001 Nissan Quest

1 Answer

BROKE DRIVER'S SIDE SLIDING DOOR HANDLE-2001 NISSAN QUEST

ANYONE KNOW WHERE I CAN BUY THE HANDLE FOR SLIDING DRIVERS SIDE DOOR. ANY INSTRUCTION TO INSTALL ALSO?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 4,369 Answers

Tascafordparts.com same car as villager

Posted on Mar 10, 2009

  • gerry bissi Mar 21, 2009





    SECTION 501-14A: Handles, Locks, Latches and Mechanisms

    2001 Villager Workshop Manual
    REMOVAL AND INSTALLATION


    Handle —Exterior, Sliding Door

    Assume you mean exterior. you did not say.



    Removal Exterior Sliding Door Handle


    1. Remove the sliding door latch remote control. For additional information, refer to Latch Remote Control—Sliding Door .

    Latch Remote Control —Sliding Door

    Removal


    1. Remove the rear sliding door trim panel. For additional information, refer to Section 501-05 .

    2. Position the watershield aside.

    3. If equipped, disconnect the sliding door power door lock actuator electrical connector.


    4. NOTE: Mark the position of the sliding door rear latch cable adjusting bracket before removing the bolt.
      Disconnect the sliding door rear latch cable.

      1. Remove the bolt.


      1. Remove the sliding door rear latch cable adjusting bracket from the latch remote control.


      1. Disconnect the sliding door rear latch cable from the latch remote control.

    5. Remove the 4 sliding door front latch bolts.

    6. NOTE: If necessary, transfer parts to the new sliding door latch remote control.

    7. Remove the sliding door latch remote control.

      1. Remove the bolts.


      1. Remove the sliding door latch remote control. he sliding door exterior handle.


      1. Remove the nuts.


      1. Remove the sliding door exterior handle.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove the rear sliding door interior panel on 2001 Nissan Quest?


Mostly clips, screws hold the handle on and bezel around it has clips that can carefully be pried off.. A door panel tool should be used to enage and pry panel clips off

Aug 22, 2014 | 2001 Nissan Quest

1 Answer

How to remove door panels with door shut


use slimjim with window up to grab rod from outside handle to latch

Mar 27, 2013 | 1993 Nissan Quest

1 Answer

Part of the driver side outside door handle for my 1999 Nissan Quest broke and it is still attached but will not allow me to open the driver door from the outside. Nissan no longer makes this part and I...


you need to remove door trim panel for access. Ford has one but you will have to paint it. buy a psray can of paint at an auto astore. paint code on your driver door opening sticker.
quest & villager are same van, built at same plant by Ford, Nissan powertrain.

Go to our site and read files. everything about villfewr quest. 3000 members. I was Ford manager of service issues on this van. I can get you part number and you can order from tascafordparts.com at discount. I also have shop manual & wiring book for sale $20. Let me know.

http://groups.yahoo.com/group/villagerquest/

Dec 13, 2010 | 1999 Nissan Quest

1 Answer

My driver side sliding door handle broke off. I had locked all the doors since and the lock is jammed. It won't go unlock so I can open it. Really my question is in two parts. How do I get my door unjammed...


open the front door...
now you have to push the locking rod towards the rear so you can open the sliding door from the inside
just follow the B pillar down and use the passenger side as reference of that black rod

Feb 10, 2010 | 2002 Nissan Quest

1 Answer

I have also broke off my 2001 Nissan Quest sliding door handle on the driver side. Also the sliding door cannot be opened from interior... Any help is appreciated... Thanks


the child lock rod may have been extended...
open the driver side door, and with a skinny finger, push that child lock rod back in towards the rear of the sliding door
use the passenger side as reference
once you pushed it in, you can now open it from the inside handle

Oct 06, 2009 | 2001 Nissan Quest

2 Answers

Im looking for a sliding door handle for a 2000 nissan quest van.


ebay has them all the time also, go here for help on Quests http://autos.groups.yahoo.com/group/villagerquest/

Jun 01, 2009 | 2000 Nissan Quest

1 Answer

2007 Quest: The passenger side sliding door will not open


There is a wiring problem on your drivers side passanger door switch.

May 10, 2009 | 2007 Nissan Quest 3.5 Minivan

1 Answer

Broken door handle - 2001 Nissan Quest SE


first you van order parts at discount from tascafordparts.com.
quest & mecrury villager are the same vehicle made at the same assembly plant. good luck to all. If you were in detroit area, I wold help you.

Trim Panel —Sliding Door Removal
  1. Remove the sliding door trim panel finish panel.
532ac84.gif 2. Remove the sliding door trim panel 2965fbe.gif Latch Remote Control —Sliding Door Removal
  1. Remove the rear sliding door trim panel. For additional information, refer to Section 501-05 .
  1. Position the watershield aside.
  1. If equipped, disconnect the sliding door power door lock actuator electrical connector.
f373e91.gif
  1. NOTE: Mark the position of the sliding door rear latch cable adjusting bracket before removing the bolt.
  2. Disconnect the sliding door rear latch cable.
  3. Remove the bolt.
  4. Remove the sliding door rear latch cable adjusting bracket from the latch remote control.
  5. Disconnect the sliding door rear latch cable from the latch remote control.
b8f2f32.gif
  1. Remove the 4 sliding door front latch bolts.
NOTE: If necessary, transfer parts to the new sliding door latch remote control.
Remove the sliding door latch remote control.
  1. Remove the bolts.
  1. Remove the sliding door latch remote control.
cb5ee71.gif
Handle —Exterior, Sliding Door Removal
  1. Remove the sliding door latch remote control. For additional information, refer to Latch Remote Control—Sliding Door .
  1. Remove the sliding door exterior handle.
    1. Remove the nuts.
    1. Remove the sliding door exterior handle.
0c820f3.gif

Mar 08, 2009 | 2001 Nissan Quest

1 Answer

I have a Broken Exterior Sliding Door handle


tascafordparts.com same car as vilager

Jan 16, 2009 | 2001 Nissan Quest

1 Answer

2001 Nissan Quest - Broken Exterior Sliding Door Handle


you can do this. you have to remove inside trim panel for access. if you still need to do, I will send you repair steps. let me know

Oct 16, 2008 | 2001 Nissan Quest

Not finding what you are looking for?
2001 Nissan Quest Logo

Related Topics:

730 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...