Question about 2006 Ford Five Hundred

1 Answer

How do I access the spark plugs for replacement on a 2006 Ford 500?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

Bad news. you have to remove the intake manifold to replace the rear three plugs. difficult; not impossible. good luck.

Posted on Mar 16, 2009

2 Suggested Answers

  • 564 Answers

SOURCE: simply replace spark plugs - procedure?

pretty simple just screw them out and replace them you may need an extention with a swivel but you shouldnt have any major problems, remember to always hand start the plugs in the ports before using a wrench to ensure they are properly threaded.

Posted on Dec 29, 2009

  • 180 Answers

SOURCE: where are the spark plugs on a 2006 ford 500?

in the middle of the valve covers under the coils

Posted on Feb 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

COIL PACKS KEEP BLOWING ON 2006 V-6 FORD FUSION


2006 ford 500 number five coil pack keeps blowing, what could be causing this ?

Feb 16, 2012 | 2006 Ford Fusion

1 Answer

How to replace spark plugs in 2006 explorer xls


Click this link below and go through the procedure:--- http://technoanswers.blogspot.com/2011/05/how-to-replace-spark-plugs-in-2006.html --------------- This should help you to replace spark plugs.Thanks.Helpmech.

May 21, 2011 | 2006 Ford Explorer

1 Answer

How to replace the spark plugs on 2006 E 150


MOST VANS HAVE A HUMP INBETWEEN THE SEATS UNDER THE DASH! THERE SHOULD BE A LATCH ON EACH SIDE OF THIS HUMP, THAT WILL LET YOU GAIN ACCESS TO THE ENGINE FROM INSIDE THE VAN! FROM THERE YOU CAN REPLACE THE PLUGS!

Mar 05, 2011 | 2006 Ford Econoline Cutaway

1 Answer

Where are the spark plugs on a 2006 ford 500?


in the middle of the valve covers under the coils

Feb 22, 2011 | 2006 Ford Five Hundred

1 Answer

Ford 500 turns over but wont start.


there could be a number of problems the most common of which is the fuel filter i recommend changing that first also doing a tuneup including, new oil, spark plugs, plug wires, air filter, and oil filter.

Feb 04, 2011 | 2006 Ford Five Hundred

1 Answer

Firing Order diagram for 2006 Ford Explorer


Hope this helps. The ignition coil:
  • changes low-voltage pulses from the PCM to high-voltage pulses.
  • fires 2 spark plugs simultaneously.
  • has 3 transformers.
    • One transformer fires the spark plugs for cylinders 1 and 5
    • One transformer fires the spark plugs for cylinders 2 and 6
    • One transformer fires the spark plugs for cylinders 3 and 4
Spark plug wires:
  • carry high-voltage pulses from the ignition coil to the spark plugs.
The spark plugs:
  • change high-voltage pulses to spark at the gap, which ignites the fuel and air mixture.
The firing order is 1-4-2-5-3-6.

69efa96.jpg

Jun 06, 2010 | 2006 Ford Explorer

1 Answer

My 2006 Ford 500 will turn over but wont start. I


You should actually check the fuel pressure with a gauge, you can probably borrow one from AutoZone. I would think you should have around 40 PSI. There should be a test port on the fuel rail (chrome tube on top of the engine). It could be a plugged fuel filter or frozen gas line if you're in a cold climate.

Jan 11, 2010 | 2006 Ford Five Hundred

2 Answers

Where are the spark plugs in the 2006 ford expedition


The spark plugs are located below the 'coil pack' in a hollow tube in the head. You must remove the spark coil retaining screw to access the removal of the soark coil. The reoval with expose the spark plug at the bottom of the hollow tube in the head. The total spark coil is about 6-7" long and when it comes out that is when you will see the spark plug at the bottom of that tube. It sounds difficult to find but once you know it is easy. There is no coil wire(typical spark plug wire) attached to the spark coil. It is fed by a special connector on the side of the spark coil. Look on the side that has the least number of hoses and equipment in the way. Find the top of the spark coil (about 1-3/4-2" in dia) with a wire connected on the side. There is a single small metric bolt holding the spark coil in place. It will not come out until that screw is removed. I hope that this helps.

Oct 18, 2009 | 2006 Ford Expedition

Not finding what you are looking for?
2006 Ford Five Hundred Logo

Related Topics:

539 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...